Fenders generate lot of vibrations .... so it is better to cover as much as possible .. You can see we went deep inside the fender to cover the maximum area
Not a good photo ...
Ghulam Hussain faithfully covered all the exposed sheet metal surfaces
Now this is the right rear fender
Can you see and feel the heat we worked in ...
We made sure that all surface of the fender is covered ... it is impossible to see this area with eyes ... and you work with feeling the surface with your finger tips .. not easy
Working in cramped spaces is very tiring ... in our 3-hour session today, both of us consumed about 8 liters of water, and other liquids including mango milkshake, tea, and lassi ... It is important to keep yourself hydrated
Even the strips require further cutting according to the surface to be covered
Working on flat surfaces is easy and quick ...
right outer surface done neatly ...
Now this is the big flat surface behind the rear bumper .. it is covered with a plastic panel which was removed to access this area ...
We kept the wires and the holding clips exposed in case there is need to access them in future