ALL accord mounts from the 6th gen will be used. You will need the accord rear, front (can be substituted for h22a front mount also), MANUAL not automatic tranny mount, and accord driver side mount (slight modification will be needed)
The MANUAL tranny mount, front, and rear will be simple bolt-ons.
The DRIVER SIDE mount has to be modified to fit (see picture 1 below). simplest way to do this is to loosely bolt the other three mounts in place and draw out a template for the mount on a piece of cardboard, then cut it out and see if it fits the mount, after that mark the holes and trace it to a piece of steel or something sturdy, cut it out and bolt it in.
NOTE: There is very little clearance between the firewall and intake manifold, you will find that it is easier to install the motor around if the secondary butterflies are removed.
THANK YOU!