Survey by Qualaroo
+ Reply to Thread
Page 3 of 3 FirstFirst 123
Results 41 to 49 of 49

Thread: engine overhaul cost of Baleno 1.3l...personal experience

  1. #1
    PakWheeler Follow
    waqas34's Avatar
    Join Date
    Apr 2009
    Location
    Lahore
    Age
    35
    Posts
    445
    Follows
    1
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Problems Posted
    0
    Problems Solved
    0
    Best Answers
    0
    Good Answers
    0

    Default engine overhaul cost of Baleno 1.3l...personal experience

    hello guys
    recently i get my baleno engine overhauled...its 2005 JXR 1.3...cause to overhaul engine was poor acceleration, oil decrease issues and unnecessary vibration and missing of engine...i would like to share the prices of all engine parts that were replaced during this process so they may be helpful to you...if anyone feel like any article is under/over prices please let me know about it

    Piston 3000/-
    Rings 1800/- (made by khiradia)
    Oil pump kit 1400/-
    Main big end 1200/-
    Clutch Pressure plate (jcc) 5000/-
    Clutch bearing 450/-
    Engine oil (shell) 1100/-
    Thrust 225/-
    Timing belt 660/-
    Timing bearing 850/-
    Wall seal set 800/-
    Engine seal set 450/-
    Jane kit 125/-
    Head Gas kit 450/-
    Silikon 100/-
    Shilling 100/-
    Water Body 1450/-
    Rocker Spring 300/-
    Labor charges of Kharadia 4300/-
    Labor charges of mechanic 4000/-

    hope it would be helpful for all guys planning to overhaul their engines

    Guns Don't Kill People.............People Kill People!!!

  2. #41
    Senior PakWheeler Follow
    hash4u's Avatar
    Join Date
    May 2005
    Location
    Islamabad
    Age
    38
    Posts
    24,366
    Follows
    18
    Following
    0
    Mentioned
    404 Post(s)
    Tagged
    13 Thread(s)
    Problems Posted
    0
    Problems Solved
    4
    Best Answers
    3
    Good Answers
    13

    Default

    how much amount did u spend in total?

    Overhauls in pk dont last much. hope urs goes smooth and fine
    Life is short and very unpredictable just like a Quarter mile .....

  3. #42
    Senior PakWheeler Follow
    Skill's Avatar
    Join Date
    Aug 2009
    Location
    Select City
    Posts
    7,885
    Follows
    3
    Following
    2
    Mentioned
    94 Post(s)
    Tagged
    40 Thread(s)
    Problems Posted
    0
    Problems Solved
    0
    Best Answers
    0
    Good Answers
    0

    Default I wonder

    new
    https://www.facebook.com/skillgrafik

  4. #43
    Senior PakWheeler Follow
    Skill's Avatar
    Join Date
    Aug 2009
    Location
    Select City
    Posts
    7,885
    Follows
    3
    Following
    2
    Mentioned
    94 Post(s)
    Tagged
    40 Thread(s)
    Problems Posted
    0
    Problems Solved
    0
    Best Answers
    0
    Good Answers
    0

    Default More expenses

    I left d idea to repair pressure pltae baught new daikin japan,about mountings i bought qabli 3 pcs in 2000,power pump exchanged in 1000 qabli,tapet rod 700 qabli,choke sensor with grip n a crank sensor grip all in 1000,star set case complete 2000 qabli,generator bearings 320 nsk japan new,hose pipe crp japan 150.
    Still engine to install. . .
    Laith gays asking 4 6250 it was done in 5500
    they done boring in 1000,crank grinding 400,main line c/rods 250,engine valves 2500,guides 800,seating 700,head facing 400,came main line 200.
    https://www.facebook.com/skillgrafik

  5. #44
    PakWheeler Follow
    waqar_naturalperson's Avatar
    Join Date
    Apr 2010
    Location
    Karachi
    Age
    32
    Posts
    4
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Problems Posted
    0
    Problems Solved
    0
    Best Answers
    0
    Good Answers
    0

    Default problems of my baleno

    i'm facing so much problem in my baleno car "car is so much missing and other problem is that when i drive the car and if i use the brake then rpm of my car decreases and car also heatup then car stop and then when i start, it takes time to start then after some minutes the car again that type of problem"
    so please give me advice that what should i do .. and which macanic is perfect for solve that types of problems..the car have been computerized checked but the computer could not find out the problem...Please Help me

  6. #45
    Senior PakWheeler Follow
    Skill's Avatar
    Join Date
    Aug 2009
    Location
    Select City
    Posts
    7,885
    Follows
    3
    Following
    2
    Mentioned
    94 Post(s)
    Tagged
    40 Thread(s)
    Problems Posted
    0
    Problems Solved
    0
    Best Answers
    0
    Good Answers
    0

    Default

    Quote Originally Posted by waqar_naturalperson View Post
    i'm facing so much problem in my baleno car "car is so much missing and other problem is that when i drive the car and if i use the brake then rpm of my car decreases and car also heatup then car stop and then when i start, it takes time to start then after some minutes the car again that type of problem"
    so please give me advice that what should i do .. and which macanic is perfect for solve that types of problems..the car have been computerized checked but the computer could not find out the problem...Please Help me
    Quote Originally Posted by waqar_naturalperson View Post
    i'm facing so much problem in my baleno car "car is so much missing and other problem is that when i drive the car and if i use the brake then rpm of my car decreases and car also heatup then car stop and then when i start, it takes time to start then after some minutes the car again that type of problem"
    so please give me advice that what should i do .. and which macanic is perfect for solve that types of problems..the car have been computerized checked but the computer could not find out the problem...Please Help me
    heating problem k liyay fan check karo radiator cap chenge kero 250 ka hai japani phir b heat kary tou 3/400 mai radiator wash karao phir b heat kary then get thermostate valve open karo n at last go 4 head gaskit 500 ka acha milay ga 1000 laboure.mising k liyay plugs check karao aur cng pe mising k liyay air filter tyt kero aur is k pipe main tape laga k hawa kam janay do engine mai
    https://www.facebook.com/skillgrafik

  7. #46
    PakWheeler Follow
    waqas34's Avatar
    Join Date
    Apr 2009
    Location
    Lahore
    Age
    35
    Posts
    445
    Follows
    1
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Problems Posted
    0
    Problems Solved
    0
    Best Answers
    0
    Good Answers
    0

    Default

    Quote Originally Posted by Skill View Post
    I left d idea to repair pressure pltae baught new daikin japan,about mountings i bought qabli 3 pcs in 2000,power pump exchanged in 1000 qabli,tapet rod 700 qabli,choke sensor with grip n a crank sensor grip all in 1000,star set case complete 2000 qabli,generator bearings 320 nsk japan new,hose pipe crp japan 150.
    Still engine to install. . .
    Laith gays asking 4 6250 it was done in 5500
    they done boring in 1000,crank grinding 400,main line c/rods 250,engine valves 2500,guides 800,seating 700,head facing 400,came main line 200.
    i hope now you can understand that why my mechanic charged 4400 Rs for the laithman...thanks yaar...mri bhi confusion khatam hogai...after observing your bill it seems "YAAR MAI TU SUSTAY MAI HI ***** GIA...hope your experience go well...as far as im concern, i m satisfied with my car to the date...but you never know about tomorrow
    Guns Don't Kill People.............People Kill People!!!

  8. #47
    Senior PakWheeler Follow
    Skill's Avatar
    Join Date
    Aug 2009
    Location
    Select City
    Posts
    7,885
    Follows
    3
    Following
    2
    Mentioned
    94 Post(s)
    Tagged
    40 Thread(s)
    Problems Posted
    0
    Problems Solved
    0
    Best Answers
    0
    Good Answers
    0

    Default Hope 4 goodness

    Waqas !
    U really lucky.
    In my scene every thing ie not only engine but steering,suspension,electric sensors,cng kit ,advance emulator,generator,self,a/c,brakes,radiator,bearings,gear,seals,lighting system,lock system each n every thing is inspected, serviced/changed.
    I wish goodness 4 ur car n u.
    https://www.facebook.com/skillgrafik

  9. #48
    PakWheeler Follow
    waqas34's Avatar
    Join Date
    Apr 2009
    Location
    Lahore
    Age
    35
    Posts
    445
    Follows
    1
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Problems Posted
    0
    Problems Solved
    0
    Best Answers
    0
    Good Answers
    0

    Default

    Quote Originally Posted by Skill View Post
    Waqas !
    U really lucky.
    In my scene every thing ie not only engine but steering,suspension,electric sensors,cng kit ,advance emulator,generator,self,a/c,brakes,radiator,bearings,gear,seals,lighting system,lock system each n every thing is inspected, serviced/changed.
    I wish goodness 4 ur car n u.

    u know what would be the best solution in the situation like your car???i would have sold my car and add up this over hauling cost and buy a new car (even i have to buy a baleno again)...yaar jb sari car hi jawab dy gai thi tu phr itni mehnat or itni takleef uthany ki kia zaroorat thi???
    Guns Don't Kill People.............People Kill People!!!

  10. #49
    Senior PakWheeler Follow
    Skill's Avatar
    Join Date
    Aug 2009
    Location
    Select City
    Posts
    7,885
    Follows
    3
    Following
    2
    Mentioned
    94 Post(s)
    Tagged
    40 Thread(s)
    Problems Posted
    0
    Problems Solved
    0
    Best Answers
    0
    Good Answers
    0

    Default Dear waqas!

    goodness again.
    https://www.facebook.com/skillgrafik

+ Reply to Thread
Page 3 of 3 FirstFirst 123

User Tag List

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •