if it wasnt a mono ,it wdnt have fryed my jvc speakers
Mashallah... Congrats
Suggestions: 1.Add front components.2. Since it is a SPL setup, its better to add a class D mono amplifier (more efficient and less burden on the electrical system)3. Get a tuned box.4. Its nice that you are adding a capacitor. they really help.5. Change the battery to chassis ground with a heavy gauge cable, minimum 4awg.
waiting for more pics and vids of the install
thank u for the wish & the suggestion im planning to do all this in a month or so as im almost broke after geting all this stuff just changed the abtery to a 65ampere one 3 days bki think for the component ,il have to tun them with the amp,so il be needing a 4 channel amp for that n wil have to take off the crunch
Nice system
thankz man
camera shake doen't show that it's a powerful sys..........
bro it's a 2ch amp.........
coz mono amp doesn't have bridge mode,and ur setup must be running at 4ohm bridge.......
i know its not much powerful at the moment but stil it's good enough for me
a little diy i did,the sub was @ 1ohm,shifted it to 4ohms
Sir jz
u shifted it to 4 ohm, its a d2 type R
and d4 would have been shifted to 8 ohms by same method :).
Diy is always fun, i burn things and learn through that LOL o sorry
very nice setup bro
thankz for the correction:)btw wt suggestion do u have for me to run this baby?
thank u
u stil didnt learnur lesson kiddin
looking nice
my sole suggestion would be to get a mono block, and i can design u kik @ZZ box. expect a 40-50% gain in performance and whole new level of low frequency responce :D.
try getting Vtrek amp from khi
i have a mono it's vtrek, brand new box pack, if u want i can ship it to u, and it's in ur budget, gives around 1000-1200rms at 1ohm......my contact no is 0322-2240269
nice setup mashAllah
No vtrek amp gives 1200rms, it's only 1000rms@1ohm, some people also say that it gives 1300rms
watever it is, sir mtx, i am quite impressed with its performance
balke i would rate it higher than f-10d :o