Assalam u alaiqum!
Recently my bike has started giving smoke from engine hole which is above the engine head and the level of smoke is sufficient to be noticed easily when its on standing position.
I am talking about a small outlet or sort of a circular 1cm outlet which is above the engine and below the curburetor (just to give you the idea about the place of it).It used to throw air in normal condition but now its throwing out a lot of white smoke and along with there is some oil also.
My reliable mechanic has not seen it but on phone call he said it is a ring piston problem.
I need a expert advise on it.I too think that my pocket is in grave danger
so is this a Piston ring problem or could be a small issue?
could it be a air filter?Curburetor problem?
LAst month curburetor was having some issues with the float level ans also i havent changed air filter since ages i guess
yes its a ring piston issue,,
when the piston moves up compressing all the gair and fuel mixture idealy there should be no way for the gases to come back all the gasses has to be pushed up by piston,,however if rings are not making proper seal with cylinder wal ,,as the piston moves up it will furthwer compress te micture and that mixture will escape past the leaky rings,, and into crankcase where it would escape through any hole that it finds,,
do it at the earlies,, as doing this will only result in just either rehoning (razmaal sa jo aik cross hatch surface banatha hain cy;linder ka inner surface pa) and new rings and u may be lucky to reuse piston,,however luck hits very few times,,
so anothere probability is that u may need to rebore the cylinder,new piston and new rings,,,