those stupid nozzles get clogged because of hard water.
follow these steps
- Remove the nozzles and put then in acid. You will notice a lot of foam being produced. This is the acid cleaning the nozzles.
2 For further cleaning use a needle to open the holes.
3 Keep dipping the nozzles in acid until the foam stops.
4 Add a bit of max liquid/shampoo into the water reserve. This helps neutralizing the hard water. Max liquid is better.
5 For best results fill the reserve bottle with water that you can collect from the drain of a split A/C. This water is wonderful because infact its distilled water. Its free from contaminants and virtually free of dust. This is the purest form of water you can find now a days.
Actually the nozzles get clogged when water dries up inside them. Hence if you are not using the nozzles frequently then try not to pump water into them.