@Nos
Yaara i thought every 1 here is a team player.. khair anyways as n elder brother this is my responsibility to enlighten u ....
Dude if u look at the topic its to "enlist Drag tracks" ok now thats no 1.
now as far as ur views on burningg... ..
Here are few basic facts.
What is a DRAG RACE:
Drag racing is a form of auto racing in which cars or motorcycles attempt to complete a fairly short, straight and level course in the shortest amount of time. The most common distance is one quarter of a mile (402 m).
now Tyres for Drag:
Well for a drag race we dont use stock tyres or but tyres wich have only 1/8 inch tread at most can be used, drag-strip tyres have no tread at all...
The type of tyre used in drag racing is often called a "slick" because of no tread.
The race is not long enough to cause the tires to overheat. But they do get plenty hot, as the car spins its wheels.
They are made of a soft compound of rubber, which affords better traction, but they tend to wear out very quickly. The sidewalls of slicks are designed for straight-line performance, rather than cornering. They are also made of a soft compound, which are designed to give way to any stresses. Wrinklewalls, as they are called, will look very strange when you mash the accelerator. The power from the engine goes through the transmission and rear-end components, through the axles, and is applies to the rear tires. The slicks try to rotate, but are resisted by the friction of the ground. The tire ends up spinning faster at the center of the wheel than at the outer edge near the ground, which results in the tire wrinkling around a portion of the bottom of the tire.
The physics behind the wrinkle is this: when the slick wrinkles, the tire creates a larger contact patch with the ground, or area where the surface of the tire and the ground are in contact. larger the contact area greater will be the friction causing the tyres to wear out easily.
usually ppl here have hardly any idea abt the slicks and they usually jump on a Drag Track with all the turbos etc.. without having proper slicks and proper burning of the slicks cuz before the drag it is required for a quick start to have ur tyres Hot on a water sprayed surface...
So that at the start of the drag wheels tends to spin as minimum as possible...
God yaar is that enough or should i go on....
thrs so much technical stuff dude abhee jeb barey ho gy tu perh loo gy dont worry...
just relax and yeh thanx for the info abt "Peshawar Phase 6/7 Hayatabad,Saddar"
I always appreciate the Young blood..