Engine Missing In Cold Start and Hesitate while Acceleration

[Demonoid]

My cultus is hesitating alottttttt now...but this occurs suddenly and momentarily and keeps on going again and again... Its like even if i press the accelerator till floor, the rpm keeps on falling and seems like the engine power is totally cut...and within 2 seconds the car is back to normal and runs perfectly fine!!! In the morning/cold start, yes it gives a good amount of smelly white smoke and then all is ok and smokeless...showed it to Enercon Scanning Karachi and he said all sensors are fine as no Check light..he said efi cultus me cng ki electronic T/lambda masla hai isko manual wali laga dete hain hopefully you will good to go...but the problem stands unresolved!

Please give your valuable input..

Please note i have brand new plug wires and plugs...new air filter, tappets setting done...

Get compression test, seems like you valves or valves seals are leak

[abid110]

Get compression test, seems like you valves or valves seals are leak

But how come engine runs perfectly fine 99% of the time? Do u think of MAF sensor being clogged
?

Sent from my QMobile Z10 using Tapatalk

[razaafridi]

But how come engine runs perfectly fine 99% of the time? Do u think of MAF sensor being clogged
?

Sent from my QMobile Z10 using Tapatalk

Sometimes minor problems with the sensor are not detected by the scanner and can only be checked through an amp/voltmeter. Does your car tends to give you the same problem in Petrol aswell?
Mine has a very different problem, everything is fine but i have this little jerk issues in the morning and then its not smooth while shifting gears, at every gear when i release clutch with acceleration pushed it kinds of breath and loose pressure and gives you a stumbling ride. I dont know what this could. I even checked both the O2 sensors and they are fine. I am forcing toyota to change my throttle body under warranty but they are hesitant saying that its a new car and there seems to be no problem with it. But yes a local car cab have manufacturing faults and that is my verdict to them. I hope they replace it.

[abid110]

Sometimes minor problems with the sensor are not detected by the scanner and can only be checked through an amp/voltmeter. Does your car tends to give you the same problem in Petrol aswell?
Mine has a very different problem, everything is fine but i have this little jerk issues in the morning and then its not smooth while shifting gears, at every gear when i release clutch with acceleration pushed it kinds of breath and loose pressure and gives you a stumbling ride. I dont know what this could. I even checked both the O2 sensors and they are fine. I am forcing toyota to change my throttle body under warranty but they are hesitant saying that its a new car and there seems to be no problem with it. But yes a local car cab have manufacturing faults and that is my verdict to them. I hope they replace it.

Car behaves perfect on petrol...no issues at all...all issues on cng only... All scanners are ok and fine as no Check light...

Sent from my QMobile Z10 using Tapatalk

[razaafridi]

Car behaves perfect on petrol...no issues at all...all issues on cng only... All scanners are ok and fine as no Check light...

Sent from my QMobile Z10 using Tapatalk

Then its the problem with CNG. Check CNG kit's Diaphragm, coversion button, wiring, gas variation inlet knob. Try having a kit clean up and reinstall with all the things in order.
I hope it solves the problem.

[abid110]

Then its the problem with CNG. Check CNG kit's Diaphragm, coversion button, wiring, gas variation inlet knob. Try having a kit clean up and reinstall with all the things in order.
I hope it solves the problem.

I suspect a gas blockage somewhere in piping...went to dealership today. They said your plug wires are not genuine ones and this could also be a cause. They wanted me to throw away my current brand new wires and install their own costing 10,500...

Is a blockage in piping of cng possible due to which car doesnt get enuff cng sulpply suddenly?

Sent from my QMobile Z10 using Tapatalk

[FBB]

I suspect a gas blockage somewhere in piping...went to dealership today. They said your plug wires are not genuine ones and this could also be a cause. They wanted me to throw away my current brand new wires and install their own costing 10,500...

Is a blockage in piping of cng possible due to which car doesnt get enuff cng sulpply suddenly?

Sent from my QMobile Z10 using Tapatalk

Cultus plug wires for 10,500/- ???

Sent from my Z12 using Tapatalk

[abid110]

Cultus plug wires for 10,500/- ???

Sent from my Z12 using Tapatalk

Jee bhai!!! This is suzuki 3s!!!! Kon maintain kr sakta hai car unse!

Sent from my QMobile Z10 using Tapatalk

[aamirq]

did u get the throttle body serviced? there is even a possibility that your fuel filter is choked! when was the last time that u got the cars fuel filter replaced?

[chiragdureja.hce]

Hi all,

I have the same problem since last 2 years. When i run my car in morning, it starts with petrol and when converted to cng it give jerks/missing for 40-50 seconds(500-600 meters).After that it run smooth. I have checked from 3-4 mechanics, but no one have the solution to it.
My car is polo 2011 model
Total Kms run:1,15000 Cng:80000
Any leads would be appreciated.
TIA.
+91-9255552525