Installing components in door:
step 1 : make spacers out of wood,for this i used 3 spacers of 0.75inch on each side.
step 2: place the spacers on door panel and mark the best position possible with a pen.
step 3 : take a wood saw( electrical) and cut the outer trim
step 4: then mount the spacer inside the cutted space by constant grinding the edges, until its properly in
step 5: now with a pen mark the inner hole, for cutting...
step 6: cut the inner whole
step 7 : put raxine or carpet on to the spacer, and screw it from the back..
step 8 : do the outer finishing of the plastic panel
step 9: the heart breaking part: cutting the door a little bit for the midbass.
step 10: install the comps and ur done



