What are the resistance values?
Have you tested the wiring in the car? Dash to engine?
Learnt from previous posts that,
It is one way valve. Air can blown from A to B, but not from B to A. It should also rattle. Carburetor cleaner is used to clean it.
cylinder is bad, you need a replacement block to get the best service life out of it, suzuki G10 block has siamesed cylinder cast and the liners are not pressed in - they are placed in the cast then the aluminium is poured around it.
okay, now i have the relay installed with the coil. I feel some improvement in acceleration and slightly increased idle speed
Did you install it yourself?. Post a picture please, if possible.
no, I visited an electrician "saeed" , @syncview recommended him, and he did a great job at it, no wires were spliced.I will post a pic later
Suggest a fuel cap for khyber. Its brand name and price range. Its the clicking type cap on my car.
Read earlier posts and found out that my fuel cap is loose and does not make pressure/popping sound, meaning it is somehow leak.
@axe.effect please post the link to the post about fuel. Sorry I don't know of any fuel cap so can't recommend.
Post 1167 and 1171. Put 'fuel cap' in search box for more details. Using correct terms make it easy to find info.
After a drive, I noticed my khybers fuel cap is loose too as there is no pressure release sound. This may be the reason of inaccurate fuel gauge reading when car is cold and hot.
Guys what is the reason of speedo needle oscillating continuously while driving or at a constant speed?
Bought original thermostat valve which is for fx but fits khyber. It was 650rs including the gasket and is NTC 82 C.
I haven't fitted it yet as I need to flush the cooling system. @xulfiqar if I make a 1:15 solution of citric acid and use about 3 liters of that solution how much baking soda will I need to fully neutralize it after draining it? what should be the ratio and liters used?
The speedometer cable is not firmly connected to the back of speedometer
Is it easy to take out the speedo and tighten the cable?
Need to replace headlights i . think. Very bad lights...seems like chrome is finished so no properly reflecting causing abrupt light in night...need to know cost
Sent from my HUAWEI G610-U20 using PW Forums mobile app
Front lights1250 rs one headlight Taiwan (non chinese).700 rs one headlight Chinese.
Market price may vary.
I will post light projection comparison picture tomorrow.
This is what my calculations show,4.3 litre water (4300 grams), 5% citric acid powder (215 grams), 2.5 % baking soda (107.5 grams).
Radiator flushing and cleaning.
Note: baking soda (meetha soda) and baking powder are not the same.
1:20 would be dilute as I have a lot of rust. What I'm worried about is that the reservoir is reducing water at a faster rate right now which means I might get major leaks after flushing [emoji20]. Will check for leaks tomorrow before attempting to flush it.......
why do you want to flush when your engine block is cracked