Toyota 1980 KE-70 Swap or built advise

[hunainahmad12345]

i just bought Toyota 1980 KE-70 with Stock 4k engine condition is 6/10. Runnig before on CNG, Now i shifted to petrol doing some start issue when car sit alone for 5 6 hours.
Should i spend money on this 4k engine or just make swap , in future my mind is to swp with best 1800cc or 1600cc engine also supension

Can anyboody guide me about engine and price also the best suspension with related to that enigine.
Also i will use this car daily driven also to Learn drift.
Am new in this. Am from Multan

[pwuser153157067741]

You can check my thread. Get a 7k efi. Best engine if you're starting. Go to 13s when you can. Don't go for coilovers right now. When you plan for coilovers do get Corona/Cressida 4nut breaks which you can use for bigger brakes. This will save you on coilover conversion and then later big brakes. Don't spend any money on 4k sell it for scrap value. Rest get Cressida LCA, extend tie rods, cut and weld your steering end knuckles "kaan" for more angle. Weld diff if you want to drift otherwise leave it open.

[hunainahmad12345]

Thank you for your reply.
7k swapped need suspension and brake updates from stock? , as power increased
Can yuo give me approx price for engine and where i can get it easily , rawalpindi or ?

[pwuser153157067741]

You can find 7k in pindi, kohat, mardan, Peshawar Lahore everywhere. Get a civic engine get it rebuilt will cost cheaper than kabuli. No need for suspension or brakes upgrade. That is for future advice. Approx price for civil 7kefi with 5spd is 100k in civil. Kabuli is 2+. Karachi mein shershah mein milay ga aram say. Udhar contact Chahiay ho to WhatsApp kardena 03104717238.

[sardarg]

rebuild the same 4K engine without any problem. with ac the fuel avg in-city will be 13+ kms and upto 15 over long run. rebuild parts from thailand are available. scrapyard engines are no no as i have read and understand from this forum.

[pwuser153157067741]

Well I got a scrap 7k for 15k that was on standard Needed the assembly since my previous 7ke was blown. Otherwise I think he won't need any part from Thailand takreeban sab available hai here

[pwuser153157067741]

Could the members recommend a solid workshop to get rust repair work done in Lahore. Profix and all motor are out of my budget even though I have experience with them. Will be replacing all panels that are available new and the rest standard denting.