As i didn't get admission in uet lahore caz of 1 mark :'(..and my dreams were scattered...and i had nothing to do....and my mind was bursting with tension..so i starting doing this diy..
PLz pry that i get adm in uet taxila.....
SO THINGS U'll NEED ARE AS FOLLOWING:
1: Any pcb(i used bread board)...any plastic strip can aslo b used...eg small plastic scale/ruler.
2: Bright orange leds( amount accordin to design)...fused one r very closed to orange incandecent light..but lumens r low..
3: Solding gun...can also use heated screw driver 
4: Solding wire/Solder
5: 1K/1000 ohm "JAPANESE RESISTORS" (this is the most important thing...may sure always to get Japanese 1K resistor..normally the shopkeeper don't give them but u can emphasis and they'll give)
6: Jigsaw/saw to cut pcb
7:Mirror paper/silver nail polish
