Engine oil flush

[shazo]

i guys i want to flush my engine oil before adding new, kindly some one guide me a good oil flusher which is easily available at lahore..current oil in engine is dirty cz i over drive it and if ill put a new oil in it, it will get brown n dirty too.

[agecoo]

I will say u donnt use any engine flush .The best way to came out from this go to the person who changes the oil tel me to flush all dirt oil then put the screw again and tight it then pour litle new oil in the engine and the wait few seconds and then again open the screw ,the dirty oil will come out .
Now put all oil and change the oil early .
this is the best option i am teling u ,

[devilz_apprentice]

@agecoo, y r u suggesting desi totkas? how can u even start the engine on lesser than required quantity? it will screw ur engine! Putting in new engine oil in lesser quantity and starting the engine for a while will not do any good.
Engine oil flush are a must products! These are to be used every 4-5 oil changes.
@Shazo bhai, u can engine flush by liqui moly. It'll cost PKR 750 from montgomery road or any shop which sells liqui moly products. However, there is an official distributor of liqui moly on Brandeth road by the name of Mobil House. He has the engine flush for abt PKR 480. I usually get all my liqui moly products from him.
I can vouch for the performance of Liqui Moly's Engine Flush.

[shazo]

@agecoo this wont do anything bro as the @devil said it will screw ur engine. thanks for input

[shazo]

@agecoo, y r u suggesting desi totkas? how can u even start the engine on lesser than required quantity? it will screw ur engine! Putting in new engine oil in lesser quantity and starting the engine for a while will not do any good.
Engine oil flush are a must products! These are to be used every 4-5 oil changes.
@Shazo bhai, u can engine flush by liqui moly. It'll cost PKR 750 from montgomery road or any shop which sells liqui moly products. However, there is an official distributor of liqui moly on Brandeth road by the name of Mobil House. He has the engine flush for abt PKR 480. I usually get all my liqui moly products from him.
I can vouch for the performance of Liqui Moly's Engine Flush.

thanks bro, yea as far as i heard liqui moly products are good and effective but if they came 1#, ill check that address which u have mentioned .

[agecoo]

bro i didnt said him to start read my thread again bro,
I just said pour litle as the litle oil wil pas through the engine inside area the dirt particles wil also move down .

[agecoo]

i have used liqi moli 450rupes per botle .they r useles.

[onlyfaith]

engine oil flush is recommended before oil change specillay if engine is not too old.

[irfansiddique]

no need of oil flushing.

[shazo]

^^ y? if the liqi moly is 1# then it will work, flushers basically remove all the dirt, blackness from the engine parts, and keep engine clean, but if original, its not necessary that liqi moly is recommended, any other u guys think is effective then please share. thanks for the input guys

[babarhashmi]

i flushed my car's engine yesterday before oil change, product used is liqui moly as its the best infact my bro gave it to me he changed oil last week n its written on the bottle it can be used to flush a car engine having capacity of 6 ltr oil, both the cars r 1300cc(use 3.5 ltr each) so we used half in each car.
well how i did it...just went to oil change shop n poured half bottle before flush and start the engine for 10 mins then flushed oil. New oil was ZIC HIFLO as its a 15 years old margalla. Have not felt any remarkable change but i m sure it must have cleaned the engine.

[shazo]

hmmm good, in order to judge the effects of before after i suggest to open tappet cover before flush and check the condition, then screw it back and then complete flush treatment. before putting new oil unscrew it again and then check,, i know its a long process but to give remarks to product u have to do this test, ill do and then post before after shots

[fahadsoulsnatcher911]

my cars oil change is also due and was also thinking of getting engine oil flushed
a couple a days ago i went to buy oil from metro and there i saw STP engine oil flush it was about 350 but was a small bottle
ill buy it in a couple of days will let you know

[shazo]

ahan looking forward

[onlyfaith]

i flushed my car's engine yesterday before oil change, product used is liqui moly as its the best infact my bro gave it to me he changed oil last week n its written on the bottle it can be used to flush a car engine having capacity of 6 ltr oil, both the cars r 1300cc(use 3.5 ltr each) so we used half in each car.
well how i did it...just went to oil change shop n poured half bottle before flush and start the engine for 10 mins then flushed oil. New oil was ZIC HIFLO as its a 15 years old margalla. Have not felt any remarkable change but i m sure it must have cleaned the engine.

i ve done it a couple of times. the best method is that your car should be warm enough and pour the flushing oil cane then idle for 3-5 minutes and then drain the used oil along with the oil filter..
the catch is that after pouring a flushing engine oil ( Liqui moly, whizz, STP, ABRO motor flush etc...never ever drive the car.only idle for 3-5 minutes.

[fahadsoulsnatcher911]

would any one suggest me to do oil change my self at home
I have all tools needed and have the owner manual too

[babarhashmi]

my cars oil change is also due and was also thinking of getting engine oil flushed
a couple a days ago i went to buy oil from metro and there i saw STP engine oil flush it was about 350 but was a small bottle
ill buy it in a couple of days will let you know

fahad plz don't use STP, i had a worst exp of it in 2009 we use to have a diesel corolla used stp n it started giving white smoke, use liqui moly its the best n not too exp i think 550 for a bottle not sure coz my bro bot it.

[babarhashmi]

hmmm good, in order to judge the effects of before after i suggest to open tappet cover before flush and check the condition, then screw it back and then complete flush treatment. before putting new oil unscrew it again and then check,, i know its a long process but to give remarks to product u have to do this test, ill do and then post before after shots

I didn't open tapet cover but when oil cap was removed i notice while pouring liquimoly it was brownish from inside n when the oil was drained it was more blackish though i changed oil after 3800Km n whenever checked from dipstick it wasn't that black so i guess it worked. plz do share ur result.

[fahadsoulsnatcher911]

fahad plz don't use STP, i had a worst exp of it in 2009 we use to have a diesel corolla used stp n it started giving white smoke, use liqui moly its the best n not too exp i think 550 for a bottle not sure coz my bro bot it.

Really ? Figures that why it was available at Metro
Ok ill do it wit Liqui Moly
Another thing the cars current mileage is around 198800 km's so shoud i wait for 200k km's or do oil change now ?

[babarhashmi]

i ve done it a couple of times. the best method is that your car should be warm enough and pour the flushing oil cane then idle for 3-5 minutes and then drain the used oil along with the oil filter..
the catch is that after pouring a flushing engine oil ( Liqui moly, whizz, STP, ABRO motor flush etc...never ever drive the car.only idle for 3-5 minutes.

i did the same, car was warm enough before oil change (drove 10km before oil change) n idle start for 10 mins after pouring liqui moly. one more thing after oil change left the car idle again for 5 mins then drove.