Anyone who has had an engine bored out before can help.
For those of you not familiar with the flat 4 engine of the Bub there's a pic below. YOu have the crankcase in the middle followed but the Barrels (with psitons) and the cylinderheads at either end.
Basically your can get big bore kits from abroad, consisting of barrels, pistons and rings. I've been luck to get one and inshallah going to get the Machining done here.
The pic has got the barrels and pistons in the red circle, and the read arrows show wear the machining is required.
One arrow at the cylinder head (LEFT) and the other on the crank case side.
HERE 'S the QUESTION
Anybody know of a good machine shop or people compitant of doing the job? Let me know Oh and i'm in Isloo so pindi and isb is a better bet.
Thanks in advance
K