A Series Vs Z-Gen Series....! Discussion..!

[SER_GTR]

Hello!
well 4AGZE is not the thing you find like piece of cake....!
you can find 4AGE 20V ST and BT .......but the 4AGZE 16v is very rear find in not only shershah but in whole pakistan....!
its not getting rear in all over world as its becoming bit old and not much of them are produced as compared to 20V and old 16v Varients....!
you can use 20V ST 2nd gen and make it 4AGZE.....it works awsome.....! as 2nd GEN ST shares bottom end of 4AGZE from AE101 GTZ.....!
B/w...you might get your hands on GZE from pesh/queeta market...you can try in SHOBA
REgards

[Suzuki1]

@SER_GTR
i saw one 6 to 7 months back in sharsha but at that time im not interested in that .. the owner force me to buy that but i reject that. and as far as converting 20V to GZE im not interested in that i want the original one if ur in karachi i hope u saw that 82 corolla without hood had 4AGZE i aslo saw that engine but its in pretty bad shap and the other prob is that ... that GZE is come in MR4 producing 140HP max

[ahsan1702]

2ZZGE VVTL-i + forged internals + boooooooooooost

[SER_GTR]

@Ahsan...Halka Hoja :P...!

@Suzuki1......! Where U seen 4AGZE 7 -8 months back :S...its very rear find man.....!
well 4AGZE comes in MR2 as well as in AE82(some US Models) as Well as in AE92 and the last varient comes in AE101 GT-Z......!
There exist 3 4AGZE's.....! the earlier MR2 one was 140hp back in 86...its uses AFM as Load Signal...!

Then 2nd Gen GZE comes in AE92 having MAP as load signal + power is increased from 144hp to 164hp.....the 2nd gen GZE have NON TVIS Manifold and DLI's with Twin Coils and Small SC Pulley...!

Then 3rd Gen GZE comes having all same spec except some minor changes as it have dual muffler setup in AE101..and its the last GZE comes.....!

And Yes that 82 Rolla back 2-3 years have 4AGZE.....!and i do makes lotta power on RW...listen much about it..but later i listen that it cracks block....

Regards

[GLI]

The 2NZ-FE is a 1.3 L (1298 cm³) version built in Japan. Bore is 75 mm and stroke is 73.5 mm, with a compression ratio of 10.5:1. Output is 63 kW (85 hp) at 6000 rpm with 121 Nm (89 ft·lbf) of torque at 4400 rpm. Some cars get the VVTi 2NZ-FEs and some get the non-VVTi version. The Corolla CBU 1.3 sold in some countries has the non-VVT-i version whereas the Yaris sedan has the VVT-i version. The VVT-i does not change the horsepower output, but rather alters with the valve timing according to driving conditions.
(Wikipedia).

[Suzuki1]

@Ahsan
2ZZGE VVTL-i + forged internals + boost lolzz
talking is an easy job and doing this is hard in reality u do that swap and be happy.

@SER_GTR

Thanks for your info bro !

[ahsan1702]

... thanks for telling me whats hard and whats not, but next time ... dont.

[Suzuki1]

hmmm i think ur right i dont have to tell u next time bez u cant do that u stick with ur 1000cc

[SER_GTR]

Now This is what i hate in b/w good going Discussion 8o|

[Suzuki1]

this is some thing for 4a-ge lover's clean swap in 74 rolla

[civic19952]

dear SER_GTR
can u please tell me what is the latest specs and changes in 11th Generation 2NZ-FE . because it was introduced in 1999 and i want to buy latest one 2015 swap pls tell me the latest specs and changes so i buy correct and desired swap

[SER_GTR]

dear SER_GTR
can u please tell me what is the latest specs and changes in 11th Generation 2NZ-FE . because it was introduced in 1999 and i want to buy latest one 2015 swap pls tell me the latest specs and changes so i buy correct and desired swap

It Came Plain Initially ...Now Its VVT-I Powered ... Better Revving ....Better Fuel Economy....

Dont Buy 11th Gen 2NZ Auto Though.....They Are Sluggish .... M/T Seems Just Fine...

[civic19952]

ok thanx, so wats your opinion about 1ZR 1.6L is it good swap?

[civic19952]

ok thanx, so wats your opinion about 1ZR 1.6L is it good swap?

[pwuser147940218716]

I wanna swap engine in 86 ... Till now I having decided to swap 7afe bcz I don't want heavy engine in my 86 to harm my chassis and suspension also I am fan of offroading but can't afford jeap cuz I am student so right now I am preparing 86 for that
So I need your expert views on my swap is 7afe good choice keeping in view my use or should I change my choice
Note : I need a car like on which I can visit Muree Naran kaghan hunza skardu so don't suggest me a heavy engine
Or me motorway per overtake bhi bardasht ni krsakta kisi ka to at least meri car 200 km/hour touch krni chahye motorway py lolzzzz
Now I need your engine suggestions

[shafinasir1]

hello brothers! I have a 95 corolla with 7A in it but I feel it is too sluggish and so I wanted for a swap with a latest possible engines. by latest possible engine I mean the engines that can bolt in, in my 95 corolla and I like the silence of latest engines. I love the silence of corollas like xlis' and beyond.
I have searched and I like the 1ZZ-FE but dont know that fits in 95 corolla or not.
so please suggest me for a good comfortable swap!
thanks,

[pwuser150078550550]

The only suggestion for both 86 & 95 corollas is either 4afe rock engine or 1nz strong ecnomical and soft. Maual transmission is

[ryanali1991]

[ryanali1991]

quick question i am using 2nzfe auto ecu on 1nz mt is there any problem in that or should i switch to 1nz manual ecu as the mechanic said that we do it all the time both ecu have same wiring same pinouts , but i think the mapping in both should be different as there is bore stroke difference in both . or toyota ecu is self learning type ?? suggestions .

[SER_GTR]

1nz ecu on 1nz engine