Fawad bhai, baat simple si hai. There's always a first initiative by someone before rest of the world follows.
I would like to tell you that it took me multiple work->thread_review->work sessions to finally unlatch the panel.
I thought the hardest part would be the bottom 8mm nut. But nopes. The hardest most criticial part is the one below as per your post
and finally I would like to contribute one suggestion to your DIY, the following might not be the correct way to pull the right side latches.
Instead, one should ask a helper to place his hand from beneath the console...(the point where FAN speed connector is placed and apply a pressure from the back side of the old Kenwood heat sink.
That, coupled with a grip from front as follows
Apply Small burst of force from front along with a constant push from back and it will pop out nice and easy.
I hope this can help the future Club members.