Honda City Fan Club

[pwuser154420855868]

Hi everyone
My 2018 Honda City is only driven 6K by now.
First oil change was done after 6 months / 2K on the odo and now when the second oil change is near I can see a drop of approx. 0.5 litre in the oil level. Can anyone explain me why This could have happened or if this happened with someone else too ?

[crude101]

How did it get damaged. Mechanic ustaad nusrat fateh ali?

[crude101]

Company wont let u claim and put the blame on you. Give it a try but do carry a moti stick along in case u need to try hard and convince them. Dealerships are looters

[anwarshahbazch]

How did you know that there is a drop in oil. There should not be any drop of oil with a new car.

[pwuser154420855868]

Obv from the dip stick. Anyone knows what could be the problem ?

[anwarshahbazch]

dip stick did not shows the quantity of the oil. It should be somewhere between the two points (holes on dipstick). If it goes below the lower point then there is need to worry. A little fluctuation can occur due to topography of the parking floor. A slope of 1-2 inches cannot be traced by the human eye but can cause difference in fluid levels.

[akpakistan2016]

A.o.A my Honda City Idsi is jerking (loss of power) (pechay ke taraf daka) in cng mostly in 2nd and 3rd gear. The car starts jerking only between 1500 to 2000 rpm while pressing accelerator after changing gear and releasing clutch. The jerks only starts after driving it 5 to 10 kms. My mechanic repaired all my ignition coils that were leaking current and the cng jerking problem got resolved for few days. But after 10 days the car again started jerks in cng. I have changed 4 of the rear ignition coils 4 days ago as i hoped that it might be ignition coil problem but the problem persists. In petrol it is not jerking but the acceleration time lags very much means as soon as i release clutch in 1st gear the accelerator does not work and the car rpm goes lower than 700 but in second attempt it starts working it does it every time mostly in lower gears only in petrol. Plz help me the air filter is clean, throttle body cleaned a two days ago and the front ignition coils that were leaking current were repaired with silicon adhesive.

[imran26june]

A.o.A my Honda City Idsi is jerking (loss of power) (pechay ke taraf daka) in cng mostly in 2nd and 3rd gear. The car starts jerking only between 1500 to 2000 rpm while pressing accelerator after changing gear and releasing clutch. The jerks only starts after driving it 5 to 10 kms. My mechanic repaired all my ignition coils that were leaking current and the cng jerking problem got resolved for few days. But after 10 days the car again started jerks in cng. I have changed 4 of the rear ignition coils 4 days ago as i hoped that it might be ignition coil problem but the problem persists. In petrol it is not jerking but the acceleration time lags very much means as soon as i release clutch in 1st gear the accelerator does not work and the car rpm goes lower than 700 but in second attempt it starts working it does it every time mostly in lower gears only in petrol. Plz help me the air filter is clean, throttle body cleaned a two days ago and the front ignition coils that were leaking current were repaired with silicon adhesive.

Dear please go to some authentic mechanic or workshop and ask them for Engine Compression Test.

It seems your engine lost the power. BTW which model do you own & what is ODO reading?

[hammad225]

No , he just informed me when he opened the brake, no body k owa how it happened , earlier the beake service was done by dealership, anyways the issue is resolved got it changed from dealership

[crude101]

Chalo good that the issue is sorted

[roony]

changed under warranty? only single piece was changed?

[shoaibrauf104]

how much did it cost ?

[hammad225]

No, i had to pay, rubber doesnt come under warranty , its written in booklet
3 rubbers containing packet was given which had 3 liquid packets as wel
1 round rubber as shown in pic and 2 others
They changed all the rubbers of left brake
Yes one packet has one side rubbers

[hammad225]

Rubber part price 2850
Labor charges 2500
Two brake oil bottles 2620
One bolt changed 260
8000 something in total

[hammad225]

This is the condition of the rubber which is changed

[hammad225]

[shoaibrauf104]

thanks.

[crude101]

Good

[pwuser156529611660]

Hey guys, so i have the City IDSI (auto) 2007 model, swapped engine to a kabuli one, so ive been using many different engine oils over the past few years which include Honda, PSO, Shell, Zic and now Total Quartz 4000, i want to change to Liqui Moly and the viscosity im using is the regular 20W/50 as per all the mechanics recommend, should i move to Liqui Moly and also should i carry on the same grade for oil or not ?

[sameerulhaq064]

Switching oil brands is not advised at all. Keep one brand and one viscosity otherwise you'll damage your engine.