Liana owners & fan club

[abid110]

mechanics asking 4k for labour...gasket is of 550-600 of taiwan .. oil bhi new aye ga..

seriously, aik aur 8k ki lagg gaii jaib ko...abhi tou car bus park hai , dirt jama ho rahi hai..uski taraf dekhne ka bhi dil nahi chah raha...

[NiGhTShAdE]

mechanics asking 4k for labour...gasket is of 550-600 of taiwan .. oil bhi new aye ga..

seriously, aik aur 8k ki lagg gaii jaib ko...abhi tou car bus park hai , dirt jama ho rahi hai..uski taraf dekhne ka bhi dil nahi chah raha...

4k is too much ....normally mechanics charge around 2k for this job...

[abid110]

4k is too much ....normally mechanics charge around 2k for this job...

they said liana ka head kholna takes 4-5 hours...its very hectic etc

[car_bus2008]

Is it me or everyone feels like me that my liana driver side is lower than passenger side.But when i get measurements with tape measure then its same.Only m getting feeling from inside that driver side is down than passenger side.

[NiGhTShAdE]

they said liana ka head kholna takes 4-5 hours...its very hectic etc

There is nothing special in opening Liana's head. It is exactly same as of any other car...

[saboor73]

mechanics asking 4k for labour...gasket is of 550-600 of taiwan .. oil bhi new aye ga..

seriously, aik aur 8k ki lagg gaii jaib ko...abhi tou car bus park hai , dirt jama ho rahi hai..uski taraf dekhne ka bhi dil nahi chah raha...

My advise will be to go a good quality gaskit these taiwani one are usually fiber one get a good quality one you can get custom one made from teen hatti near lasbeela

[saboor73]

Is it me or everyone feels like me that my liana driver side is lower than passenger side.But when i get measurements with tape measure then its same.Only m getting feeling from inside that driver side is down than passenger side.

Share a pic of your car

[saboor73]

Temp needle shows temperature of the coolant...
It could be faulty temp sensor or its wiring.
Gasket isssue are not uncommon in Pakistan and are not limited to Liana. You would find them in every type of car and they are due to poor maintenence. These new Aluminium engine blocks are quite sensitive. Just one heating and their headgaskets are gone..

Does tap water damage temp sensor

[harib4u]

maybe right. but this will be done now ASAP.

i myself have started hating the car. it has made my life seriously miserable. lucky few who enjoyed it

brother car ko maintain to karna parta hai, koi b lo gy kharacha to ho ga, 4-5 din ho gy hen mery pas 2 liana hen around 50K ka kam karwa chuka hu, abi b 15 se 20K or lagy ga. ak hafta pahly jo blue wali thi us par b 22K kharch kia tha.

what is thermostat valve? and it needs to be removed?

use for quick heat up & maintain car temp

mechanics asking 4k for labour...gasket is of 550-600 of taiwan .. oil bhi new aye ga..

seriously, aik aur 8k ki lagg gaii jaib ko...abhi tou car bus park hai , dirt jama ho rahi hai..uski taraf dekhne ka bhi dil nahi chah raha...

gasket change laber is 2000-2500.

[Proverbial_Slang]

Temp guage sensor not working can be due to 2 reasons.
1- Tap water in cooling system resulting in rust and salt scales on sensor.
2- low coolant due to leakage in lower part of cooling system. The steam won't reflect accurate temp as there won't be direct fluid in contact with the sensor ( less likely)

Sent using Curiosity's onboard communications sytem.

[NiGhTShAdE]

Does tap water damage temp sensor

It could... Tap water has ability to corrode metals due to is dissolved solids but nature of water varies with region to region. At some places it is more corrosive while at other it could be less damaging. At lower pH and more TDS water could become more corrosive like that of Karachi and Islamabad. On the other hand in most of Lahore water quality is comparatively good resulting in much lower corrosions..

[NiGhTShAdE]

Does tap water damage temp sensor

Without right proportions of anti freeze there is a great possibilty that temp gauge with not work properly. Anti freeze increases the boiling point of water making it possible for water temp to rise with engine for greater range of temperatures. If you use simple water it boils of at 100'C and say under cooling system pressure it would boil of at few degrees more than 100 but them it would start turning into steam and its temp would stay constant from that point onwards no matter how much heated up engine is. if you have some idea of saturated and superheated steam you'll understand this better.

[abid110]

liana rakhne k liey physics dobara parhne pre gi!

wattay car!

[NiGhTShAdE]

Its not about Liana, its about every modern car where temp sensors are built into coolant lines. In older not EFi cars thermo switch for radiator fan and temp sensors were seperate. Switch was put in radiator and sensor was put in Engine block mostly...

[sufyanjaved]

Best place to get alignment who is specialized with liana alignment settings tried wheel and wheel mareer,Abid wheel mareer all are not professionals they do hit and trial......have to go 5,6 times to them to get the wheel staright with steering wheel...now want to try any other

If you live in Rawalpindi/Islamabad there is one wheel alignment specialist on PWD road. I been there my self and in my experience they are too good. Name of the shop is ALINO and they are located on the very end of PWD road going towards Behria Town.

[ussama.ghanchi]

Salam brothers, my liana car front suspension is like there is nothing between tyre and body.. Every slight bump gives the noise of jump hitting the body very badly.

Please suggest suspension work specialist in khi..

[harib4u]

any one know price of liana front wheel baring price.?

[abid110]

i was talking to my parosi who deals in used complete engines. he said that usually its not possible that head becomes trouble free if it has experienced gasket issue and over heating. all engines coming now of almost all cars are disposable. if issue comes, throw the cylinder block and put in other one.

[Skill]

any one know price of liana front wheel baring price.?

Bearing number is DAC 40720036 and is 2RS means both side covering rubber seals .
Price vary from brand to brand Japanese like koyo or ntn is around 2.5k each and a good chinese brand like kyk would be around 1k and will long good 20k +

[Proverbial_Slang]

Bearing number is DAC 40720036 and is 2RS means both side covering rubber seals .
Price vary from brand to brand Japanese like koyo or ntn is around 2.5k each and a good chinese brand like kyk would be around 1k and will long good 20k +

A lot of fake NTN in the market since the last at least 20 years. One has to be careful while buying. A layman can't tell the difference so one should try buying from reputed dealers or a trusted mechanic (who might want to keep a few hundred in his pocket).