Liana owners & fan club

[abid110]

Is this position fine?

This is the optimum temperature condition of engine. Needle should never cross this level or its bad..

[enthusiastic.learner]

brother min ap say apni gari k suspension k baray min kuch discuss karna chahta hon.kindly send me ur mobile number pls

Check PM

[enthusiastic.learner]

Is this position fine?

That is beautiful. It should stay there.

[aatir_sheikh]

This is the optimum temperature condition of engine. Needle should never cross this level or its bad..

Abid bhai kal parso iss ki koi hose loose hune ki wajah se gari H ke paas pohanch gayi thi. Lekin i got it fixed immediately. Engine wagera pe farak toh nhn parra ho ga?

[cracked]

It it the optimum temoerature? My liana temp gauge stays below this point. I have t stat installed,caltex coolant poured and auto fan. Plus i had checked with suzuki shop,the fan kicks in at 98'C and brings down the temp to 92 and then fan stops. The needle stays about 40% mark of total gauge.ill post picture tomorrow

[03154040868]

Post your query here for the information and benefit of all of us

brother meri gari ka ye mala hay k gari ka suspension subah k waqt bara naram and smooth hota hay laiken jaisay jaisay gari travel karti hay gari ka suspension hard feel hota hay.min soch raha ho k gari ka tamam suspension over hall kar walon.shock to nay dalway hain 2 mahinay pahlay.min chahta ho chimto k bush or baki tamam bush change kar walon.ap bahyo say ye request hay k chimtay nay dalwao ya un k bush change karwalo.or agar tamam suspension over hall karwao to kitna kharcha ho ga,or lahore min koi acha mechanic ho to bata din

[enthusiastic.learner]

It foams a water proof seal and prevents arching you need to apply very thin layer over corner of boot man sure it does come between spark plug and coil contact point

Silicone grease is a di-electric which means it does NOT conduct electricity. Placing it between plug tip and the connection point will increase the resistance in contact and put extra strain on coils. The correct way is to take the spark plug out and thoroughly apply this grease on the white ceramic part. Then take a cotton bud and with its help, apply the grease on the inner walls of the plug boot, making sure that it doesn't reach the metal contact point inside the plug boot. Then tighten the plug back in and securely replace the boot on top of it. I wouldn't be too generous with the grease inside the plug boot for the above mentioned reason.

[abid110]

It it the optimum temoerature? My liana temp gauge stays below this point. I have t stat installed,caltex coolant poured and auto fan. Plus i had checked with suzuki shop,the fan kicks in at 98'C and brings down the temp to 92 and then fan stops. The needle stays about 40% mark of total gauge.ill post picture tomorrow

Whats the odo reading of yr car? On cng?

[saboor73]

Silicone grease is a di-electric which means it does NOT conduct electricity. Placing it between plug tip and the connection point will increase the resistance in contact and put extra strain on coils. The correct way is to take the spark plug out and thoroughly apply this grease on the white ceramic part. Then take a cotton bud and with its help, apply the grease on the inner walls of the plug boot, making sure that it doesn't reach the metal contact point inside the plug boot. Then tighten the plug back in and securely replace the boot on top of it. I wouldn't be too generous with the grease inside the plug boot for the above mentioned reason.

My bad I wanted to write that it doesn't come in contact points accidently wrote does

[abid110]

brother meri gari ka ye mala hay k gari ka suspension subah k waqt bara naram and smooth hota hay laiken jaisay jaisay gari travel karti hay gari ka suspension hard feel hota hay.min soch raha ho k gari ka tamam suspension over hall kar walon.shock to nay dalway hain 2 mahinay pahlay.min chahta ho chimto k bush or baki tamam bush change kar walon.ap bahyo say ye request hay k chimtay nay dalwao ya un k bush change karwalo.or agar tamam suspension over hall karwao to kitna kharcha ho ga,or lahore min koi acha mechanic ho to bata din

Control arm or kenchi ko change nahi kia jata, bus new bush dall jatay hain. Ball joint hota hai asal jo change nahi hota balkay repair hota hai. Ball joint alag se nahi aata. Original pair of kenchi is around 11k or so. Me ne abhi poora repair krwaya hai. Aur rackend tie rods tou new japanese leen me ne 2750 ki Senkei 555 ki best quality. Linkers bhi hotay hain 2 jin me koi science nahi, grease daal k repair ho jatay hain. Ye sab kaam me ne abhi karwaya hai sunday ko. See my posts for all kharcha.

[abid110]

brother meri gari ka ye mala hay k gari ka suspension subah k waqt bara naram and smooth hota hay laiken jaisay jaisay gari travel karti hay gari ka suspension hard feel hota hay.min soch raha ho k gari ka tamam suspension over hall kar walon.shock to nay dalway hain 2 mahinay pahlay.min chahta ho chimto k bush or baki tamam bush change kar walon.ap bahyo say ye request hay k chimtay nay dalwao ya un k bush change karwalo.or agar tamam suspension over hall karwao to kitna kharcha ho ga,or lahore min koi acha mechanic ho to bata din

Shocks konse dalwaey? Kitne k?

[Xulfiqar]

Control arm or kenchi ko change nahi kia jata, bus new bush dall jatay hain. Ball joint hota hai asal jo change nahi hota balkay repair hota hai. Ball joint alag se nahi aata. Original pair of kenchi is around 11k or so. Me ne abhi poora repair krwaya hai. Aur rackend tie rods tou new japanese leen me ne 2750 ki Senkei 555 ki best quality. Linkers bhi hotay hain 2 jin me koi science nahi, grease daal k repair ho jatay hain. Ye sab kaam me ne abhi karwaya hai sunday ko. See my posts for all kharcha.

jab baal joint loose ya khatam hojatay hain to poora control arm replace karna parta hai - iss behtreen design ke liye suzuki ko thankyou ka letter likhye.

ball joint repair har waqt kaamyab nahi hotee - aur na hi aise item ke repair pe bharosa rakhna chahiye - agar ball joint break hojaye gaadi chalte howe to aap ka bohot nuqsaan hosakta hai - jaani bhi.

[saboor73]

jab baal joint loose ya khatam hojatay hain to poora control arm replace karna parta hai - iss behtreen design ke liye suzuki ko thankyou ka letter likhye.

ball joint repair har waqt kaamyab nahi hotee - aur na hi aise item ke repair pe bharosa rakhna chahiye - agar ball joint break hojaye gaadi chalte howe to aap ka bohot nuqsaan hosakta hai - jaani bhi.

Let me guess car will suddenly loss a wheel like old double wish bone Honda with extreme worn out ball joint

[abid110]

jab baal joint loose ya khatam hojatay hain to poora control arm replace karna parta hai - iss behtreen design ke liye suzuki ko thankyou ka letter likhye.

ball joint repair har waqt kaamyab nahi hotee - aur na hi aise item ke repair pe bharosa rakhna chahiye - agar ball joint break hojaye gaadi chalte howe to aap ka bohot nuqsaan hosakta hai - jaani bhi.

Was i wrong? Please correct me for benefit of myself in particular...

[Xulfiqar]

Let me guess car will suddenly loss a wheel like old double wish bone Honda with extreme worn out ball joint

yes - and I remember that a 4 wheel car doesnt quite work with 3 wheels.

[SER_GTR]

jab baal joint loose ya khatam hojatay hain to poora control arm replace karna parta hai - iss behtreen design ke liye suzuki ko thankyou ka letter likhye.

ball joint repair har waqt kaamyab nahi hotee - aur na hi aise item ke repair pe bharosa rakhna chahiye - agar ball joint break hojaye gaadi chalte howe to aap ka bohot nuqsaan hosakta hai - jaani bhi.

Imagine A Qurabani Cow Being On 3 legs....WHY

Because It Break The Leg.......Ondhaay Mouh Girnaa Is The Correct Term I Guess

[gullahmad]

Silicone grease is a di-electric which means it does NOT conduct electricity. Placing it between plug tip and the connection point will increase the resistance in contact and put extra strain on coils. The correct way is to take the spark plug out and thoroughly apply this grease on the white ceramic part. Then take a cotton bud and with its help, apply the grease on the inner walls of the plug boot, making sure that it doesn't reach the metal contact point inside the plug boot. Then tighten the plug back in and securely replace the boot on top of it. I wouldn't be too generous with the grease inside the plug boot for the above mentioned reason.

Thanks brother for ur valuable info as it is new to me. And u also clear the full point that it resist electric current.

[welcome786]

Change the rims to make it look HOT

RIM change kar ke agar HOT Ho gai to bethe ga kon is main phir. lolz

[welcome786]

meri taraf say b 50 topon ki salami janab.or mera dil karta hay k ye topon ki salami barhti hi jay ap k liay.kahin apnay liana say shadi to nahi karli hay.q k itnay kharchay biwian hi karwati hain shohron k.u realy love your ride.i m realy very impress

mubarak ho bhai bohat sari topo ki salamiyan mill rahi hain kuch meri taraf se bhi hazir hain. lolz

[03154040868]

Shocks konse dalwaey? Kitne k?

bhai jan agri auto k shocks dalway hain.6 months waranty or 15800 k 4 shocks.yar mujhay simple batain k suspension ko repair karwao ya naya dalwao ya phir qabli.apki post ki mujhay zara samjh nahi aai