Mehran Experience Tips and suggestions

[pwuser148475613984]

Change your distributor to cdi performance will increase and they are kabli made i bought it in 4000 dont go for alloy rims for mehran as they all are china made you can buy some good quality wheel covers trust me you will need no alloys i have installed these

[tintin1]

This post was flagged by the community and is temporarily hidden.

[geforce911]

I do regular oil changes and some times even 100-200km before interval period. I asked about engine flush because i am thinking of using ceratec so it would neatly coat the inner parts of engine. However i do not see any sludge or black deposits when tappet cover is removed.

As for Alloy rims, i will look into it and search the market in free time. I prefer black rims though lol same size as stock.

thanks for your response Sir.

[tintin1]

This post was flagged by the community and is temporarily hidden.

[faisalyz]

kion

Any suggestions ?

[pwuser151890461475]

I have mehran 2007 , my engine is reducing oil , it's giving not any type of smoke , good pick although throws water on first start but it's continuously reducing oil rather not any type of leakage is observed , my friends suggest 20-50 havoline but just after 250 km oil reading is in between two holes !!!
It's in center of hight and low Mark holes
Is it ok what i should do to tackle that problem

[pwuser148475613984]

use 20w-50 oil but engine work is upon you

[harib4u]

Mehran start vibration at the speed of 70-80, and at the speed of 100-110 it vibrates too much, car only 1000km driven.

[tintin1]

This post was flagged by the community and is temporarily hidden.

[tintin1]

This post was flagged by the community and is temporarily hidden.

[hassaaniqbal92]

I have mehran 2007 , my engine is reducing oil , it's giving not any type of smoke , good pick although throws water on first start but it's continuously reducing oil rather not any type of leakage is observed , my friends suggest 20-50 havoline but just after 250 km oil reading is in between two holes !!!
It's in center of hight and low Mark holes
Is it ok what i should do to tackle that problem

you are probably checking the oil in a warm engine or on an uneven surface. Be sure to check the oil when the engine is dead cold and is on level ground.

[autophile]

Mine is 18000 kms driven and I took to Faisalabad via Motorway in December. Not a single vibration.

Since it is only 1,000 kms take it to your nearest Suzuki dealership for check up. It needs tightening of suspension bolts.

[pwuser148475613984]

Mine is 10 years old not a single vibration

[s15]

Wheel balancing issue (probably), or bent rim, bent tyre or could be faulty warped discs.

Visit Suzuki. These days, even many expensive new cars have improper alignment, tire pressure and balancing right from factory.

[mfdarvesh]

Mehran 2001 Carby
Currently using Havoline 20w/50, is it good for may I changed and to which ???
Early morning starting on CNG is problematic, takes too much self, how to solve please ??

[pwuser148475613984]

START ON PETROL than shift to cng

[mfdarvesh]

START ON PETROL than shift to cng

Thanks
Will try tomorrow ..

[s15]

Bad CNG mixture setting.

With engine at half temperature, rotate CNG mixture screw (on the CNG kit) clockwise until engine starts to die, then rotate it counterclockwise until a minimum smooth idle is achieved.

After that, your car should start at half self without pressing accelerator when it's warm and cold start should improve also.

10w-40 is better if engine is healthy, otherwise 20w-50 oil.

[m.ali7212]

Is it possible to get good Brakes of Mehran with servo booster? If yes where to find it and how much it cost?

[hotcoder]

servo makes the brakes less hard to apply. Available in Bilal Gunj or used auto parts market. It costs around Rs. 5,000.