Need some advise and help in setting the layout of the setup in Swift
I am planning to shift the Adcom to the boot on an amp rack along to support my future upgrades iA. For that purpose I would be re-wiring the whole system. The crossover of Infinity which was earlier places in the dashboard will now go to the boot. So new speaker wires will be laid from the tweets and mid-bass to the boot to support the current Passive and later Active setup that I would be running.
I believe for a strong and thorough system, the structure needs to be strong, i.e. good wiring + dampening + organized layout.
So Adcom from under the passenger seat will go to the trunk. It would be now powered with Stinger 4awg wire and will be grounded by the same wire. Later a distribution block would be added to support dual amplifiers for the setup. So now I need advise on what more should be done so that I get done with laying the blueprint of the system now and later on just hook up components to fire the built.
Will be going for
- Fuse holder + Fuse (around 100amp) 4guage
- Branded speaker wiring 16guage (probably Xscorpion)
- Wooden rack attached to rear seat
- Distribution block (1) 4 gauge IN to (2) 4 gauge OUT
I want a neat and clean install and I want everything to be organized and of best quality so would be going for proper components.
Suggestions & Comments are welcomed 
Also let me know of GOOD installers in Karachi (except Haroon Radio) 
