Toyota Corolla Model (E-120) 2002--2008 Owner's and Fan Club

[jibrankhan7200]

Any picture would be helpful?

[KamranAslam]

Can anyone guide how can I fit Console box(glove box) in Dumba.

I removed it fr cleaning a/c filter. Now it is not closing as before.
I will appreciate if any bdy guide by video.

@kamran aslam
Your engine bay seems too dirty as well as your battery terminals are bady corroded. Do something for bth

Engine bay dust I rarely used it from last 20days or more, dont know how come, terminals I did not pay attention to

@brownrose78: here is the link - hope this helps
Toyota Corolla E120 Glovebox Removal

[KamranAslam]

Pour warm water on the terminals and clean them with a scrub. After that apply some grease on them.

Warm water -- copy

[bilal65210]

Bro I have the same Issue
But couldn’t trace till now

[abdul_basit007]

I done the procedure in the way you told me. Start the car, remove the grip of MAF sensor and after few seconds car shut down. Now Check light is not going and the problem is still thr!

[pwuser155844254978]

I need 2003-2008 petrol or diesel but genuine

[pwuser155844254978]

You want to sale ?

[pwuser155844254978]

Want to sale ?

[sleeper]

Sorry....office vehicles

[pwuser155132113716]

Is this for sale?

[pwuser155844254978]

Want to sale ?

[KamranAslam]

Can anyone guide how can I fit Console box(glove box) in Dumba.

I removed it fr cleaning a/c filter. Now it is not closing as before.
I will appreciate if any bdy guide by video.

@kamran aslam
Your engine bay seems too dirty as well as your battery terminals are bady corroded. Do something for bth

Engine bay dust I rarely used it from last 20days or more, dont know how come, terminals I did not pay attention to

@brownrose78: here is the link - hope this helps
Toyota Corolla E120 Glovebox Removal

@brownrose78 : did this work ? Else will get a small mobile-video from my car.

[KamranAslam]

[brownrose78]

@KamranAslam
Thanks bro, my brother has fitted glove box himself (He saw the trick during a/c servicing at a/c shop)

[nawan885]

Be aware of dirt degree collection in side skirts. I was servicing my 2D saloon 2008 when found side skirt loose. I opened it up and see how much mud is collected there. I was unable to open whole but it 1/3 is opened and see how much mud is removed. Any one know how to open whole side skirt as I was unable to open whole rivots

[jibrankhan7200]

Brother any picture of your 2Ds engine bay?

[pwuser152411620847]

[waqar19]

I done the procedure in the way you told me. Start the car, remove the grip of MAF sensor and after few seconds car shut down. Now Check light is not going and the problem is still thr!

Sorry i should have mentioned that never pull out or plug in sensor grip on a running engine. It turned off because ECU didn't got enough time to compensate
the MAF signal loss when grip was pulled out.
Narrow down your diagnose step by step. Check all sensors and coils grip by grip.
[I suspect its MAF or faulty coil. Could be (cps) crank position sensor but faulty cps cause backfire ]

[capsat]

@abdul_basit007 please start a new thread with issue as subject line and share what have you attempted so far with your vehicle history

in such mall like thread problems & gossip get mix up

[abdul_basit007]

Noted bro!