2007 Honda Civic ivtec manual cruise control

[farrukhzaibno1]

Asalam o Alaikum Shamaal Bhai congratulations on doing such an effort and getting succeeded also and top of that is you had shared all your experience with the others and explained all the things very deeply . But one thing i wanted to know is that is the Manual ECU is capable of cruise control just needs few things to line up or the ECU must be replaced at any condition . Because Cruise Control just comes in the orial model as you know so the ECU of Hard Top and the Prosmetic is different of just few wiring and control buttons and few other things are enough to turn the cruise control with the same ECU ?

[pwuser160623311490]

I have the same situation as you, can anyone help me?

[jcboy]

After reading zunny's posts I agree with you @pwuser153247015751 . There are two things unclear here for new learners:

1. The brake switch #3 where in the MICU/Fusebox to connect? As far as i know it is Ignition switched battery voltage only, Im not sure what that "yelllow wire near the red wire" is for. But yes, please clarify if we tap on yellow wire (i think Connector E #28 is it?)

2. WHAT SIZE pins and HOW to remove dust cap to INSERT into ECU/PCM connector A 39 (and/or 41)? There seem to be rubbers there on the pin holes--i checked and confirmed that we should remove them)

Moreover, where can you source the pins @zunny? I had a hard time inserting similar (but not the same) pins. Hope it works. Still waiting for the 4 pin brake switch.

Thanks.