ATTN: Sound Gurus of PakWheels ! Advice Needed on new Setup

Technical Forums

In-Car Entertainment (ICE)

wheel

Tags: #<Tag:0x00000009f6f758>

ch33tah (ch33tah) 2013-01-29 16:43:23 +0500 #1

Edit:

I made the following purchases ... thnx to madhouse for his valuable advise

Focal 165A1SG
Pioneer 6902R
Pioneer 6500 (for components and rear)

Fusion PP-SW12E
Kenwood 626 (for Sub)

https://www.pakwheels.com/forums/car-entertainment-electronics-gps-navigation/208942-attn-sound-gurus-pakwheels-advice-needed-new-setup-2#post3783901

Hi folks,

I'v been out of touch with this stuff for last 3 years so have no idea about a sleek setup and its price.
I need some expert advice on what to buy for my new corolla 1.6 Limited Edition.
I am thinking of going with the stock LCD headunit (pre installed with new 1.6 limited edition )for the time being and changing it later down the road. My budget is around Rs40k for speakers, amp, woofer, wires, (etc?????)

Any expert advice and suggestions will be much appreciated.

Cheers!

omar1234 (omar1234) 2013-01-29 17:49:52 +0500 #2

go for components ps165 will cost you 22k giving it away at a very cheap price for your front stage

madhouse12 (madhouse12) 2013-01-30 01:52:02 +0500 #3

focal 165a1 components for front (15-16k)
jbl 1204 sub
a small mono for the jbl and a two channel amp for the focals.

roms (roms) 2013-01-30 02:56:20 +0500 #4

Focal 165A1/ Pioneer D1720
Pioneer GM9500/ Ref 800.4
Jbl GTO1214/ JBL Gt5
Sealed Enclsoure 1.25 cuft
Focal Performance RCA (2 Pairs)
Low resistance ofc wires 2.5m/ 4mm
Labour/ Installation

Latter on when you have budget you can get HU, Mono amp, branded speaker wires and rear fill if you desire.

arfanmahmood1 (arfanmahmood1) 2013-01-30 04:18:37 +0500 #5

@madhouse12 and @roms i have a question. Why we need mono for sub? Why not we use sub on 4 channel amp?

roms (roms) 2013-01-30 04:52:27 +0500 #6

Mono amps are meant to be used for subs. Mono amps are usually 2 ohm and 1 ohm stable and can accomdate more than 1 subs. They are powerful from 4 channel / 2 channel amplifiers.
Whereas on the 4 channel amp, you have to bridge 2 channels and the impeadance load must be minimum 4 ohms. Mostly 4 channel amps provide on 1/3 of the rms required by a standard sub.

Typical example:

Pioneer 309 Sub requires 400 rms
Pioneer 6500 4 channel amp with bridged mode can provide approx 150 rms@ 4ohms
Pioneer 7500m can provide 400rms@ 2 ohms
Therefore sub will get its desired rms

jz (jz) 2013-01-30 10:33:31 +0500 #7

My point of view is without a good player a setup will never have decent quality

SoundMaster (SoundMaster) 2013-01-30 10:59:54 +0500 #8

Pioneer d8604 is also suggested.

[TABLE="class: compare-table"]
<tbody>[TR]
[TD="class: feature, bgcolor: #DCDCDC, align: right"]Continuous Power Output (1 Ω, ≤ 1% THD+N)[/TD]
[TD="class: even, bgcolor: #F5F2DA, align: center"]125 W x 4[/TD]
[/TR]
[TR]
[TD="class: feature, bgcolor: #DCDCDC, align: right"]Continuous Power Output (2 Ω, ≤ 1% THD+N)[/TD]
[TD="class: even, bgcolor: #F5F2DA, align: center"]150 W x 4[/TD]
[/TR]
[TR]
[TD="class: feature, bgcolor: #DCDCDC, align: right"]Continuous Power Output (4 Ω, ≤ 1% THD+N)[/TD]
[TD="class: even, bgcolor: #F5F2DA, align: center"]100 W x 4[/TD]
[/TR]
[TR]
[TD="class: feature, bgcolor: #DCDCDC, align: right"]Continuous Power Output Bridged (4 Ω)[/TD]
[TD="class: even, bgcolor: #F5F2DA, align: center"]300 W x 2[/TD]
[/TR]
</tbody>[/TABLE]

roms (roms) 2013-01-30 11:14:19 +0500 #9

Sherry bhai have u got it?

Sent from my iPhone using Tapatalk

SoundMaster (SoundMaster) 2013-01-30 11:21:01 +0500 #10

Sir aval

usman421 (usman421) 2013-01-30 13:00:50 +0500 #11

sir ap ko jo Arsalan bhai n taimur bhai nay setup bataya hay ankhain band kr k purchase karlo bohat alla stuff bataya hay

AuNs7 (AuNs7) 2013-01-30 13:24:51 +0500 #12

SoundMaster;3730104:

Pioneer d8604 is also suggested.

[TABLE="class: compare-table"]
<tbody>[TR]
[TD="class: feature, bgcolor: #DCDCDC, align: right"]Continuous Power Output (1 Ω, ≤ 1% THD+N)[/TD]
[TD="class: even, bgcolor: #F5F2DA, align: center"]125 W x 4[/TD]
[/TR]
[TR]
[TD="class: feature, bgcolor: #DCDCDC, align: right"]Continuous Power Output (2 Ω, ≤ 1% THD+N)[/TD]
[TD="class: even, bgcolor: #F5F2DA, align: center"]150 W x 4[/TD]
[/TR]
[TR]
[TD="class: feature, bgcolor: #DCDCDC, align: right"]Continuous Power Output (4 Ω, ≤ 1% THD+N)[/TD]
[TD="class: even, bgcolor: #F5F2DA, align: center"]100 W x 4[/TD]
[/TR]
[TR]
[TD="class: feature, bgcolor: #DCDCDC, align: right"]Continuous Power Output Bridged (4 Ω)[/TD]
[TD="class: even, bgcolor: #F5F2DA, align: center"]300 W x 2[/TD]
[/TR]
</tbody>[/TABLE]

Sir are you willing to sell the d8604? @OP, sorry for going off topic.

ch33tah (ch33tah) 2013-01-30 15:22:30 +0500 #13

Sir ye Arsalan Bhai and Taimur bhai kon se hain ... All I can see are the nicks
I think you are talking about roms and madhouse?

omar1234 (omar1234) 2013-01-30 16:53:27 +0500 #14

Yes ur rite and if you need the comps then I'mthe guy for that

usman421 (usman421) 2013-01-30 18:16:16 +0500 #15

madhouse ARSALAN bai ka nick hay n roms TAIMUR bhai....sir yh dono bhai audio guru audio king hain

roms (roms) 2013-01-31 03:57:24 +0500 #16

Sir txt kar dein price. This amp is really good

roms (roms) 2013-01-31 03:58:49 +0500 #17

Thank you for kind words but, koi king shing nahi, still back benchers trying to figure out which period is it.

SoundMaster (SoundMaster) 2013-01-31 13:47:07 +0500 #18

yes bro. it is very good and versatile amp.

ch33tah (ch33tah) 2013-01-31 16:50:00 +0500 #19

Can I get price for these from any one??????
Also, from the looks of it... you are suggesting speakers in the front doors and nothing at back ????

Thanks for the help every one

roms (roms) 2013-02-01 02:34:32 +0500 #20

For accurate prices, contact sound master.
Yes nothing at back. You dont need rear speakers