CV joint or Drive shaft problem alto VXR JDM 660cc

[Ishtiaq778]

Salam , I have JDM Alto VXR 660cc. One month before I replaced the complete CV joint assembly from CHAH E Sultan Rawalpindi. Its Kabli one, couldn?t find the brand new set . Initially it worked fine, but from last five days, left side CV joint started making noise. When drive alone, on acceleration a RUBBER bound sound is heard very clearly. I visited a mechanic, who told that is drive shaft or cv joint problem. Sound is heard while straight driving alone, when any body sits on front passenger side, no sound is heard.( sory for so long)
My Question ??. Where from can is get brand new japanies CV joint???
Or should I get repair it by Kharadia?
Note: JDM alto VXR have smaller sized CV joints than PKD alto VXR 1000CC.

[Ishtiaq778]

no expert here???????????

[nfssaad]

cv joint failure is tak tak sound when turning corners.. this doesnt seem like it

[nfssaad]

rubber bound..? i dont get it

[Ishtiaq778]

Rubber bound mean, not a clear metallic sound, its coming from boot, it while driving straight, on turning left right , no sound,

[gujar96]

Check axle boots and properly check your tyres if any nail is inserted? Same happened with me and a nail with a lather strap was inserted in the tyre.

[Ishtiaq778]

Check axle boots and properly check your tyres if any nail is inserted? Same happened with me and a nail with a lather strap was inserted in the tyre.

thanx dear, i ll check this

[meh1]

this seems like CV joint problem. i had same problem in cuore. sound came from passenger side only when i was alone and going straight and accelerating in slow speed. and went for checkup of all suspension and mechanic told me to replace with kabuli. i am using it for more than one year now with no problem.
when replacing, ensure that they are not already repaired. use new good quality rubber boots. if grease has to be applied again. use proper CV joint grease. and it will be good for many years. just get them checked for torn boots at every tuning.

Salam , I have JDM Alto VXR 660cc. One month before I replaced the complete CV joint assembly from CHAH E Sultan Rawalpindi. Its Kabli one, couldn?t find the brand new set . Initially it worked fine, but from last five days, left side CV joint started making noise. When drive alone, on acceleration a RUBBER bound sound is heard very clearly. I visited a mechanic, who told that is drive shaft or cv joint problem. Sound is heard while straight driving alone, when any body sits on front passenger side, no sound is heard.( sory for so long)
My Question ??. Where from can is get brand new japanies CV joint???
Or should I get repair it by Kharadia?
Note: JDM alto VXR have smaller sized CV joints than PKD alto VXR 1000CC.

[gujar96]

Brother if it is Axle or CV joint turn your car fully towards left and right both if it makes kar kar or any noise then your CV or Axle Rod is finished.

[Ishtiaq778]

this seems like CV joint problem. i had same problem in cuore. sound came from passenger side only when i was alone and going straight and accelerating in slow speed. and went for checkup of all suspension and mechanic told me to replace with kabuli. i am using it for more than one year now with no problem.
when replacing, ensure that they are not already repaired. use new good quality rubber boots. if grease has to be applied again. use proper CV joint grease. and it will be good for many years. just get them checked for torn boots at every tuning.

You r right dear, today i checked my car thoroughly, its inner goda is making noise, outer cv joints are Ok, I replaced with kabuli one, one cv joint is creating problem. i am unable to find brand new set of cv joints

[dr3vil]

change front cross and kuppa
i had same problem with mehran and repacing cross and kuppa worked

[Ishtiaq778]

change front cross and kuppa
i had same problem with mehran and repacing cross and kuppa worked

plz explain cross and kuppa??

[dr3vil]

plz explain cross and kuppa??

its staright CV joint
it will cost u 500 to 800 in kabari places
i used lay man terms which mechs call them

[Ishtiaq778]

its staright CV joint
it will cost u 500 to 800 in kabari places
i used lay man terms which mechs call them

you are right dear, its straight cv joint issue,here in my area i am unable to get it, can you arrange it for me???

[dr3vil]

you are right dear, its straight cv joint issue,here in my area i am unable to get it, can you arrange it for me???

man if u can drive to isb or Peshawar its available

[ovais.saleem]

can any one please tell me the length,torque transmitted and material of propeller shaft of bolan?