Daewoo fan club

[Proverbial_Slang]

AoA,

Can any1 confirm if daewoo racer hubs have pcd of 110? I read somewhere on this thread that Charade rims can be put on Daewoo Racer.

[abdulr76]

Dear All, and (testDrive)

I am happy to see that now really understand GM EFI.

Could someone help me in replacement of Daewoo Racer A/C with conventional A/C used in Toyota/Honda/Suzuki etc ..... . The problem I have faced is with high/low pressure switches and ECU signaling while A/C Clutch ON.

I tried to connect conventional a/c, when it turn ON, idle speed drops or engine stop. However, A/C was working and satisfactory cooling achived.

I feel, it can be possible to connect a conventional A/C in daewoo Racer if wiring is handle properly. or 12+ will be provided to ECU desired pin.

Need valuable feed back from all and specially testdrive.

Regards,

Abdul Rauf.

[testdriver]

@shahabrk

Daewoo has the following sensors.

1. Throttle Position Sensor (TPS) - attached to throttle body
2. Coolant Temperature Sensor (CTS) - Under throttle body
3. Manifold Absoulte Pressure Sensor (MAP Sensor) - Vehicle fire wall
4. Vehicle Speed Sensor (VSS) - above gear box (leading to Speedo cable)

In addition to that, it has an Idle Air Control Valve (IAC Valve) to control the Idle engine RPMS....

@Proverbial_Slang

Daewoo's hub has PCD of 100 same as that of Charade, so you can fit them interchangeably.

@abdulr

The problem seems with the A/C relays in the fuse box. Get your car checked by an electrician. As far as replacement of the A/C system is concerned, you can also replace the whole system, since ECM only provide a signal to the A/C relay, and then it is put forward to the compressor....

[testdriver]

@proverbial_Slang

Do visit the following Website

[shahabrk]

thanks testdriver i needed that sensors list becoz i am in a process of overhaulling the egine and change all the sensors of my car also and also u didnt tell me the phenomena of the car i told u abt wa does it coz to happen that way.
thanks for the list of sensors again .

[testdriver]

Actually RPMs are adjusted on the basis of VSS during motion, so this is quite normal, if the RPMs comes down when the car is static. If the RPMs are not coming down, the Idle Screw, TPS or the CTS might be problematic.....

[Proverbial_Slang]

Thanx a lot testdriver. Really appreciate the answers. The reason I asked this question is that I have a 1985 G11 Charade and the tyre shops tell me I can't fit any other car's rims on it.

From the link u posted, it seems there r quite a few cars who's PCD matche including ppre 1992 civic and accord.

Thanx again.

[devilousangel]

subb ko salam!
Now, i need sum suggestions from the experts only. I have been playing with daewoo engine for the past 8-9 years. Yes i m the one who turbo chraged daewoo engine. Now i want more power so have planned to get some other engine for ma beast. I HATE HONDAz! so forget about the DOHC thingy. The engine which i m interested in is 4Throttle its a 20v (silver top). Now any one who has good knowledge about the daewoo and this engine can guide me if its suitable for me to swap the engine or not. Ill be greatfull.

P.S I drive on petrol so dont worry about the CNG problems.

[testdriver]

@devilousangel

Why don't you go for the engine like the one in my car? It is producing ~30N.m. more torque and ~20HP more than the TBI engine. You can play around with that engine to produce more HP, like putting a turbo. I think a 1.5L engine with ~140 HP and ~150 N.m torque will serve better. The most important thing is that you don't have to alter anything in the wiring, engine bay, and the current gearbox is bolt-on. Just the engine with ECM and wiring will cost you around Rs.30K.

If going for any other engine like 20V ST, you have to modify the engine bay, the complete wiring including the entire indash wiring, rear wiring, battery wiring, ignition switch wiring and the fuse-box has to be replaced/altered which needs an expert electrician.....If you can easily manage to do all these things you can go for the swap

[shahabrk]

thanks test driver so if i will replace the vss and tps it can solve my problem coz many cars i have seen dont do like this like increase of rpm when putting the gear on nuetral when the speed is high like 100 or 120

[testdriver]

Hopefully your problem will be resolved (y)

[akifjanjua]

Salam All,

I have a problem with my car... its heater core leaked a year back... and as usual i cut its water supply and left it like that

now these rains have actually forced me to plan a DIY on this weekend to fix the core leak.

I know the core's location and am experience in DIY fixes... but handling daewoo's fragile dashboard is not easy

I need information on this... anything that anyone knows on how to easily get the core out... which dash panels need to be opened... anybody having had similar problem or had seen dashboard dismounting.. HELPPP !!

I'll post the pics when and if i finish the job...lol...

[beeberg]

All daewoo lovers please check this link.

https://www.pakwheels.com/forumreply_az_TopicID!34642~ForumID!1~pw.html

@testdriver

adnan bhai this car is one which i saw earlier and gave token but later file was missing so cancelled the deal. later i saw cielo after discussion with you and dad it is sure that cielo parts would be very hard to find.
anyways please give comments on above link, how much price should be done for this daewoo?

[devilousangel]

helllo guys this is my daewoo deez days am working on a new project ENGINE SWAP am putting in 20v in ma beast...

[shaan]

Thank you everyone for your comments and appreciation.Quite busy since 2months thus couldnt log to Pakwheels.
Upgraded my vehicle---Replaced bumpers with original Racer one`s,Installed via DIY,rear parking lights in bumper,Got minor dents fixed,Changed battery to Yuasa 66ah original japan,replaced rear springs and shocks,new Rt engine sheet,Corona side view power mirrors.
Here are the pics:-

[akifjanjua]

im now thinking abt the brakes of my daewoo.... i have heard some success stories abt servo/master cylinder replacement with a toyotas... but i want to know more... specially those who have actually that.... are the result worth the effort.

this next DIY will take place InshAllah soon... im just trying to get the service manual to make things better

@shaan

nice car bro.... i really liked that front bumper and grill... where u got these from? custom made? let me know where u got this work done from.

[spectra]

changing only the proportionating valve gives same result as a full servo and master cylinder replacement.

[testdriver]

@shaan

(y).....Looking nice. These bumpers are of 'Fantasy' and 'Racer GSi'. For how much you got them?

@Akif

Change the brake setup if necessary. I upgraded the brake system (servo+mater cylinder) due to a problem. They were not fully supporting the new engine setup, causing brake heat-ups and early pads worn outs.

I tried the cross-linked servo+master cylinder of Cielo, but the end result was not that good....Now I am quite satisfied with the performance with the new servo I think from Nissan.....(Straigth-linked)

[akifjanjua]

@spectra

i worked on ur idea... the proportioning value could be a problem... coz while braking the rears never lockup... and its usually the fronts locking up very early resulting in a skid and poor braking.... i use a manual ABS procedure to avoid skids

i am currently reading abt proportioning valve role and its adjustments etc... will update u guys once i come up with something

@testdriver

bhai im looking into all possibilities... i liked spectra's idea... will ask u for details InshAllah

[hammed25]

well i just want to conform one thing is the daewoo brake problem is genuine.... bcoz its like after every 20 days im going to daewoo workshop for the bleading of the breaks and ofcourse i have bought new front disk pad and rear drum pad... and now i stoped driving my car in high speed... i have being sick from the breaks and please suggest what should i do its being a problem bcoz im using this as a family car if its for my personal use then i will just go on with the peoblem... as soon as im using it for my family car so i need suggestions on this....