DIY JDM Clock & Retractable mirrors Installation in PKDM Suzuki Swift

[pwuser158446093335]

Yeah seems pretty good, it dropped to 13.5 in local which is also good enough for this car.

[Massive_One]

t dropped to 13.5 in local which is also good enough for this car.

more than good i say for this car : )

[pwuser158446093335]

Only if the meter is accurate enough tho xD

[mohsan87]

BTW how accurate is this reading of fuel average?

almost 95% as I always fill up the refilling data into Fuelio App and its calculation is bit less than (approx 0.5-0.8 km/l difference) what this meter displays

[seehar97]

Hello, just a question, Do you think that this clock can be used in liana or any other car with swift engine + wiring setup?

[waailasif3]

How accurate is the outdoor temperature sensor reading for you guys have been so far? I was wondering if the sensor's placement (in the front bumper) affects the sensor reading as it is close to the engine's radiator?

[Maliko1]

For me it is still working very fi9
It is located under front grill facing out words near front fog lamp
There is nothing to do with radiator or engine bey

[mohsan87]

if you place it at the OEM location, it will tell you the correct reading because it has direct contact with the air. any other location will give you wrong reading.

[pwuser158446093335]

It is installed behind front bumper at the bottom, a bit towards the left (driver side). I guess not too far away from the OEM which is towards the right side of the bumper, I doubt that is gonna make any difference to the readings. But for some reason, I feel like it exaggerates the temperature sometimes, especially in summers.

[harisdahar]

I'm curious if there's any model number for those connector pins for BCM as I'm going to install the ambient temperature sensor myself. I went to two car electricians, but they refused to install one, at least the second electrician gave me wires, unfortunately not the pins.

[alisaeed.isb]

You only gave current connections to the JDM OEM part. How did you get the average and temperature connected. You later, in next post showed how to connect temperature sensor. Where average pins came from? Jadoo?

[voodoo]

the average is bultin the ECU and automatically works when u install this jdm clock... I have installed the same in my car... the temp sensor I have placed inside the car for now

[waheedurrahman.777]

Thank you for the detailed post you have shared. I have installed it, but there is one issue: my fuel avarage is not shown as yours. My fuel avarage numbers keep changing, and when Car is in parking mode it shows zero (---.---). my clock shows time and temp correctly. What to do? Did I Miss Something?

[waheedurrahman.777]

mera b same issue hy but only showing temp , likn avarage is keep changing .what to do ?

[emoun]

I recently installed the JDM clock from the seller you mentioned earlier. The temperature sensor is currently placed inside the cabin.

I just bought the car, so performance tuning is still due.

[voodoo]

nice... I have also installed the temp sensor inside the cabin as I already have an outside sensor separate