Honda Accord Cl9 Error Code Advice

[pwuser16925048764]

Salam, hope everyone is good, my honda accord cl9 recently started giving me the notorious blinking D light, the light started coming after the 3rd gear of my car started slipping after it rained heavily.

Upon connecting the scanner, i get the following error codes.

Confirmed DTC: Permanent
1.3rd Pressure Sw Circuit High (P0848)

Pending DTC: Temporary
1.Shift Malfunction
2.Shift Malfunction E
3.Clutch Pressure Control Solenoid Valve C Stuck Off

Kindly tell me what to do, i am based in islamabad, and do not know any good mechanics for accord, I have checked 2 mechanics, 1st one said you need to change valve body, the other one said u might need to repair transmission, or maybe even change it. I dont think any of these could be the solution, as the issue mainly presists in 3rd gear. 1st to 2nd shifts fine, 2nd to 3rd jerks, and Then stucks in 3rd, i have to put my car In N to and put into D to put 1st gear again,

Thankyou for reading and your time.

[pwuser16925048764]

Any help?

[Xulfiqar]

Welcome to Honda automatic box ownership.

You need a transmission overhaul, whoever told you its a valvebody job is partially correct, but to do that on your car, the entire transmission needs to be torn down to its bare casing because the 3 valve bodies in it are right behind the torque converter. (You can thank Honda for that braindead design) and that psp error is for the power steering switch, thats super easy to fix, it probably has a broken wire.

For the trans, its big bucks now as usd/rupee parity is in the toilet.

[dani_kk]

It looks like there's a connector of transmission fluid pressure switch either has some contact issue.
If you can visit Islamabad, you can come for the testing.
This pressure switch can pop up these two other codes too. So we need to scan it again and see is this pressure switch code due to transmission or not.

[pwuser16925048764]

Issue fixed by replaced the single valve body, car shifts smoothly now, the code for the pressure switch went itself. Thankyou xulfiqar

[hitman4life23]

How did you replace it?

[hitman4life23]

Would changing the 3rd gear pressure switch help?