JBL GTO938 vs Alpine SPS69C2

[Getafix]

Hey guys,

So i'm trying to choose between JBL GTO938 & Alpine SPS69C2. There's a shop in F-10 that has both of them.

Alpine SPS69C2 are for 6k (sticker on the bottom says made in china):

Power Handling Capacity (RMS): 50W
Power Handling Capacity (Peak): 250W
Tweeter:

• 1" Silk Soft Dome Tweeter
• Swivel Capabilities
• Neodymium Magnet

Woofer:

• Aluminum Coated Polypropylene Cone
• Nomex® Spider
• Square Voice Coil Wire Design
• Lightweight Air-Injected Rubber Edge
• Custom Fit Spacer

Frequency Response: 30Hz - 30kHz
Impedance (Nominal): 4 Ohm

JBL GTO938 are for 6.5k:

• Power Handling, RMS 100 Watts
• Power Handling, Peak 300 Watts
• Frequency Response (±3dB) 45Hz – 21kHz
• Sensitivity 94dB
• Impedance 2 Ohms

Which one should i go for? I'm going to be using them with my four channel amp. The JBL are slightly more powerful & three way. While the Alpine's are two way. I'm not exactly sure what the impedance signifies? I won't be using a woofer for now, maybe i'll get components in the future. So i just want the speakers with the best quality used with an amp.

[soulhack3r]

JBL GTO938 are clean speakers...Go for em...iv persnly heard em too they sound gr8 + built quality is awsum too

on ther othr hand alphine sounds gr8 too but dies on high volume

anyway best of luck

[madhouse12]

slightly powerful? jbl is twice as much powerful as alpine. dont look at peak power. that is useless. RMS rating is the one to go for. my suggestion would be JBL

[stj174]

JBL GTO any day

[Getafix]

Thanks guys, guess i will go with the JBL's then!