Mehran Engine Temp

shiraz.latif (shiraz.latif) 2018-01-29 17:19:38 +0500 #1

Aslam o Alaikum Everyone,

I am facing concerns over my Mehran Vx 2011 Model as the engine temp was not getting in the middle of Cold and Hot Gauge so i have installed the new Japanese radiater switch which cost me around 600 but the problem was the same the radiater fan is also on auto then i was suggested to check the thermostate valve i have installed the new thermostate valve for rs 350 Japanese. i have also installed new water body for rs 1200 but the engine temp is still not comming in the middle but slightly more left from the middle of the gauge.

Please share your thoughts

nnabeel (nnabeel) 2018-01-30 12:43:45 +0500 #2

Dude, your car temperature is perfect if it is staying near to the middle (more left from the middle). i have 2016 model and it never goes to the middle infact it stays near to the middle.

dont take tension...enjoy i think this is the standard setting for mehran.

shiraz.latif (shiraz.latif) 2018-01-30 14:56:47 +0500 #3

Thanks Brother yeah i think that after 2014 models the temp optimum level is set to this level.

aliaamar1101 (ali aamar) 2018-02-24 23:50:17 +0500 #4

This post was flagged by the community and is temporarily hidden.

shiraz.latif (shiraz.latif) 2018-02-26 13:40:53 +0500 #5

I hate Direct fan as it keep the car engine cool and the engine can never perform well while not getting to its warm state

aliaamar1101 (ali aamar) 2018-02-26 16:03:08 +0500 #6

This post was flagged by the community and is temporarily hidden.

nnabeel (nnabeel) 2018-02-27 15:52:41 +0500 #7

due to direct fan, the engine does not gets to the required temp where it efficiently burn, so the result un burnt fuel goes into the oil maiking it useless and the engine head gets weak by the passage of time