Mehran Experience Tips and suggestions

[dr3vil]

bro phir reborn kia kerni ha, boing 747 ki pray kioon na keroon ... lekin majboori ha k mery pas cultus ha is lye....

dua cultus mehran nhi dekhti

[ahmed2396]

@ekdrifter

This is the current situation of oil after using it for 2500km, the oil is ZIC A 10W40 and was poured in on 12th of june 2014 and still it is clean and ek is the level ok? I usually drain it at 3000km

[dr3vil]

@ekdrifter

This is the current situation of oil after using it for 2500km, the oil is ZIC A 10W40 and was poured in on 12th of june 2014 and still it is clean and ek is the level ok? I usually drain it at 3000km

Sab theak hai biru
Ik dam okay hai

Sent from my GT-I9300 using Tapatalk

[COOLTAHIR]

I have a question :
About My mehran's euro 2 vxr speedo meter
When i start driving from 0 the speedo needle wont start up or cross "0" position until car's goes more than 20 kmph speed?
Is it normal

[dr3vil]

I have a question :
About My mehran's euro 2 vxr speedo meter
When i start driving from 0 the speedo needle wont start up or cross "0" position until car's goes more than 20 kmph speed?
Is it normal

Go to electricition and open meter use oil or grease at the place where speedo wire connets to needle

Sent from my GT-I9300 using Tapatalk

[ab6666]

AOA
i have owned mehran for 7 years almost and most of the stuff has gone wrong so if some one has an issue with mehran he can ask me here i will be glad to help a mehran brother to put him out of this misery as mehran is a car that can make u go mad and pull ur hair a part KIDDING
so some one has problem post it here i will do my best to come up with a solution
Problem no 1: Starting in winters is a hell if ur getting late dhicka will do the trick but u need to check few things Park the car in night on petrol,Open the Self as mechs call it SULF and check barrings in it they are copper barrings and if needed so replace them else ask the electrification to clean the self,and reinstall it
then check the battery DON'T add water over the High level mark as in winters problems is that Engine OIl freezes or gets thick and it needs extra kick from the battery
other things related are clean the plugs and change the plug wires possible to 8mm ones and clean or replace the Point which comes in Distributor
also check the
+ve wire of the self is Tight to battery as most of the time its a small thing which makes u go mad

PRoblem no 2:Axel and CV joints so CV joints are too weak in mehran and 3 years of rough driving can kill them and when replacing CV joints never go for a kabuli AXEL as they tend to be repaired most of them use Chinese ones they work good and tell the Kharaiya to never temper with the length of the Axel in fitting of the Cv joints the length should be as OEM specs
and if the Straight joint is worn out replace it with Cross and the Cross kupa but be careful for length and the kuppa pick the kuppa which has the smoothest end which goes in to the Gearbox as it can damage Axel seals in gear box
always use the Original Rod of ur car as its build for ur car a mechanic will suggest u to replace whole AXEL with Kabuli but its from an older model besides most of them are repaired
Issue in top speed and pick
when i first got the chance to Floor mehran on M1 with iridium plugs and 8mm wires bought from Shoba i was really Disappointed with results car was hitting 110km/h MAX on petrol i was so mad but in this i noticed a few things which were wrong in my car
1 Cv joint of right axel
2 Cylinder Packing it made dar dar sound like old taxies after 80Km/h mark
3 and wires from shoba had no life in them they were used and abuses
so excpet for CV joint i changed wires to new 8mm which are cheaper then shoba wali Kabuli wires and Cylinder Packing plus whole exhaust had wholes so repaired it all got her tuned from ENERCON center and after a few days i hit the M1 again plus similar iridiums were in it and this time results were amazing mehran ha 165/70/12 tires and speedo was showing 130 so u can guess what it was in real speed as big tires cause speedo to give an error 100 in speedo = 112.2 Km/h in real

Ignition Coil replacement

as most of mehrans have OIL ignition coil which Comes FF and it sucks it has a limited life and mechs do make a mistake when coil dies they assume that head gasket is gone and which leads to other problems.replace coil with magnetic coil which Alto and Cultus use its way better and gives an edge in starting costs were low when i did this 600 for the coil brand new but now i herd its for 1500 or something comes in a triangle box.

Front Guarder or GADRI

as time passes Front Guarder or GADRI become rusted and weak which causes problems for mountings of the front jumping rod a new Front Guarder or GADRI is about 1000 and 4 bolts hold it in place on a non accidented car its not a big job Front bumper needs to be opened and jumping rod and 4 bolts and its the reverse process while fitting but a car which had some accident then its a job in which a denter makes some $$$$ but there is always a way around intall gaudri and all stuff and see if there is some difference on alingment of bolts of front engine mounts cut a whole with welding torch in the engine mounting plate and its easy and also make adjustments to the jumping rod u can make tires placement in the wheels where they will fit but go for some good dentor so frame can be pulled out will cost more but its the right way
installation of Foam in Doors to reduce sounds
its a simple task install some pieces of foam behind the lock wires and door handle wires inside the door
open the inner door covers first take the hadle out its held with 2 screws then take the cover of handle out held with single screw then the window winder take it out but it requires a trick rool it to a point u can see the joint end of the pit take it out with a screw driver and window winder will be free
then take the cover our its held with clips but don't put much pressure on them they can break after its out check all bolts and screws inside the doors if they are loose tight them and hit the door with ur fist so u can hear sounds now with other hand start detecting what wire is loose cut some foam and put it between the door and line
by this u can reduce 90% of sounds in mehran

I have 2 problems in my mehran 2005
1. When i relese the cluch a tuk sound is produce i have changed all front bushes along with the both chimtay but the problem still exists since 4 to 5 years

1. The pick of my car decreases after running of 7 to 8 kms. Right boot of cv joint is worn and very little grease is their only This could be the reason of decresed pick on cng? Help me Thanx

[dr3vil]

I have 2 problems in my mehran 2005
1. When i relese the cluch a tuk sound is produce i have changed all front bushes along with the both chimtay but the problem still exists since 4 to 5 years

2. The pick of my car decreases after running of 7 to 8 kms. Right boot of cv joint is worn and very little grease is their only This could be the reason of decresed pick on cng? Help me Thanx

clutch might cause this sound if u changed bushes etc
2 get it tuned yar heating se taluq hai once car gets temp then it slows down

[ab6666]

clutch might cause this sound if u changed bushes etc
2 get it tuned yar heating se taluq hai once car gets temp then it slows down

Tuning on cng? But i have recently changed spark plugs. It can be due to tappets clearence?? I have recently changed rings valve and their seals. 1. Before i changed bushes the sound was their mechanic advised me to bushes then the sound will vanish. But it is still their.

[dr3vil]

Tuning on cng? But i have recently changed spark plugs. It can be due to tappets clearence?? I have recently changed rings valve and their seals. 1. Before i changed bushes the sound was their mechanic advised me to bushes then the sound will vanish. But it is still their.

could be steering box any thing get it checked throughly

[ab6666]

could be steering box any thing get it checked throughly

Can u tell me the valve clearence of mehran

[dr3vil]

Google f8b valave settings

Sent from my GT-I9300 using Tapatalk

[ab6666]

Can any body tell me how to check the petrol average of mehran

[jazibdon]

Can any body tell me how to check the petrol average of mehran

Fill your patrol tank and drive 10 to12 km then refuel it.check the
Quantity after refueling.

[ab6666]

Hello pakwheelers. I have a query my mehran is giving me millage if 130 kms in city on 55l cng cylinder. Is it ok...

[ab6666]

And ine more thing when i release clutch the tuck sound is produce and sterring and dashboard vibrates for that instant. Mechanic told me that it is due to the play in axles. Is it true? Thanx

[dr3vil]

And ine more thing when i release clutch the tuck sound is produce and sterring and dashboard vibrates for that instant. Mechanic told me that it is due to the play in axles. Is it true? Thanx

No axels issue
Its chimta issue
May be one of shocks gutka is craked
If ur axels are not leaking never touch them else u gona be in pain

Sent from my GT-I9300 using Tapatalk

[dr3vil]

Hello pakwheelers. I have a query my mehran is giving me millage if 130 kms in city on 55l cng cylinder. Is it ok...

If its with ac then okish
Mine with ff tank gave me same milage in city

Sent from my GT-I9300 using Tapatalk

[ab6666]

If its with ac then okish
Mine with ff tank gave me same milage in city

Sent from my GT-I9300 using Tapatalk

It is without ac what should be the normal millage for 55l cng cylinder

[ab6666]

If its with ac then okish
Mine with ff tank gave me same milage in city

Sent from my GT-I9300 using Tapatalk

No axels issue
Its chimta issue
May be one of shocks gutka is craked
If ur axels are not leaking never touch them else u gona be in pain

Sent from my GT-I9300 using Tapatalk

Both chimtas are replaced recently but issue is not solved. Btw what is shock gutka. And i t can be due to play khenchi?? If not then what are the symptoms of play in khenchi

[dr3vil]

Both chimtas are replaced recently but issue is not solved. Btw what is shock gutka. And i t can be due to play khenchi?? If not then what are the symptoms of play in khenchi

Wht ever it is
Not axels
Some times foundations are also culprit

Sent from my GT-I9300 using Tapatalk