Pak Suzuki Wagon R Owners Club

[Sarkaar]

How big is the reserve tank of wagon r

Reserve start when one bar is remaining when its start blinking it is close to end, i think 3 liter of petrol approx

[ch.talal]

1. vibration on idle

you'd notice em if you're coming from a 4 cylinder car, 3 cylinder engines are bound to vibrate whether it is wagon r, Japanese 3 cyl kei car, carby cultus, mehran or any 3 cyl car, but outta all these, wagon r's engine is the most balanced and refined one(comparable to jdm cars).

2. jerk while releasing clutch

wagon r's clutch has smoothest engagement in its class, the car jerks if the clutch is released too early(it engages faster and earlier than older suzukis, more like a santro's).

Agreed.

1. Problem arises when people switch cars. Every car has got its own clutch play. Make it a habit to always release clutch slowly. You are not driving it on race track where you have got to take lead. If still clutch is not appropriate for you, get it adjusted.

[ch.talal]

Finally went to Suzuki Central Motors for 60,000km service (All services are done for the first time ever since I bought my WagonR)

Engine oil + Oil filter + Air filter
Coolent changed
And
Battery water acid drained and changed(my car battery is original)
Alignment and balancing

Cost for all the services plus taxes Rs.25,567/-

Sent from my iPhone using PW Forums

Did you ask them to change battery acid or they changed it themselves. Because it is never changed as new acid will speed up the deposits build up on already worn out plates. The correct way to change acid if required is to drain it all then wash it several times with clean water. Epsom salt is best to break away the deposits and clean the plates. After epsom salt treatment, battery is thoroughly washed and then new acid is poured.
Well car batteries are not expensive. I would go for new.

[usman_arooq2]

K10b Firring order is bit to far it vibrates more than carby cultus Suzuki should have installed counter balance shaft like daihatsu cb series engine

it has more to do with the fact that wagon r is efi therefore lower idle rpm in most cases, where mechanics used to set the idle rpm of cultus carby a bit high. when u rev the wagon r a lil, the vibrations smoothen out. in my experience, nvh levels are below coure's engine, suzuki's f10(alto), g10(both khyber, cultus) and f10 efi (faw xpv) and f10 is a four cylinder engine.

[usman_arooq2]

Agreed.

2. Problem arises when people switch cars. Every car has got its own clutch play. Make it a habit to always release clutch slowly. You are not driving it on race track where you have got to take lead. If still clutch is not appropriate for you, get it adjusted.

my point exactly, there isn't any problem with wagon r's clutch, but one needs to gets used to it.

I drive a gli 1.6(auto) and 2.0d saloon(smooth and forgiving on abrupt clutch engagement) still driving a wagon r was a breeze, the difference is felt by those coming from other suzuki cars(mehran and alto particularly).

[ch.talal]

Well If someone is worried about vibrations, get the rpm increased. It's not a big deal. You could do this on your own. But do this only if you want to compromise the fuel economy.

[saboor73]

Well If someone is worried about vibrations, get the rpm increased. It's not a big deal. You could do this on your own. But do this only if you want to compromise the fuel economy.

How on earth would one increase idle rpm on efi engine?

[ch.talal]

How on earth would one increase idle rpm on efi engine?

LoL.
There is a throttle stop screw on every throttle of efi car. Turn that screw like you tighten it to increase rpm.
The other way to increase idle rpm is to adjust it from idle air control valve.

[saboor73]

LoL.
There is a throttle stop screw on every throttle of efi car. Turn that screw like you tighten it to increase rpm.
The other way to increase idle rpm is to adjust it from idle air control valve.

And now let me complete the line "adjust stop screw and complete ruin you AFR ratio" the idle air control can also change your engine power curve

[ch.talal]

And now let me complete the line "adjust stop screw and complete ruin you AFR ratio" the idle air control can also change your engine power curve

So that is the reason I have written in my first post "by compromising fuel economy". Open your eyes and read that.

[ch.talal]

When throttle stop screw is tightened, the throttle opens. The TPS sends signal to ECU which in turn increases injectors speed. Thus idle RPM will increase but also the fuel consumption.

[saboor73]

So that is the reason I have written in my first post "by compromising fuel economy". Open your eyes and read that.

My eye are open what you aren't understanding is fuel economy isn't the only thing that would be effect you saw my post mentioning "power curves" performance of the engine will be effect the stop screw is there two adjust tps if it's get disturbs not other way around tps tell ecu about postion of throotle input so that AFR can be alter

[ch.talal]

My eye are open what you aren't understanding is fuel economy isn't the only thing that would be effect you saw my post mentioning "power curves" performance of the engine will be effect the stop screw is there two adjust tps if it's get disturbs not other way around tps tell ecu about postion of throotle input so that AFR can be alter

Read my last comment (above your comment) Mr Hot Headed.

[dr3vil]

Finally went to Suzuki Central Motors for 60,000km service (All services are done for the first time ever since I bought my WagonR)

Throttle body cleanup

Break service all disc and leathers changed
[ATTACH]1646323
[/ATTACH]

New break discs

Spark plugs changed

Transmission oil changed

Engine oil + Oil filter + Air filter
Coolent changed
And
Battery water acid drained and changed(my car battery is original)
Alignment and balancing

Cost for all the services plus taxes Rs.25,567/-

Sent from my iPhone using PW Forums

congrats on 60k
bro but why 27k bill
if u don't mind sharing the cost of stuff changed

[farhad.hassan.786]

Salam my fellow pakwheelers! today i called sarwar automobile Peshawar to ask for a sand beige wagon r vxl. he said that one will arrive tonight and you can take delivery tomorrow. so i went there and made the payment of 1035400 rupees including 1 year extended warranty.
the question is that tommorow im gonna pick up my car INSHALLAH and i wanted to ask what to check at the time of delievery? and how to properly break in my car i.e how much speed to maintain how much weight etc. answer would be highly appreciated as tommo am gonna go for delievery INSHALLAH.

[mfdarvesh]

Good Luck @farhad.hassan.786

[farhad.hassan.786]

@mfdarvesh thank you

[farhad.hassan.786]

@pakwheelsimb any suggestions

[Sarkaar]

Salam my fellow pakwheelers! today i called sarwar automobile Peshawar to ask for a sand beige wagon r vxl. he said that one will arrive tonight and you can take delivery tomorrow. so i went there and made the payment of 1035400 rupees including 1 year extended warranty.
the question is that tommorow im gonna pick up my car INSHALLAH and i wanted to ask what to check at the time of delievery? and how to properly break in my car i.e how much speed to maintain how much weight etc. answer would be highly appreciated as tommo am gonna go for delievery INSHALLAH.

Check all fluids they should be at the upper limit. Check engine oil. Check stereo, ac. Car should be clean. Spare wheel, jack, rod and pana. Nothing to worry about initial running except dont apply breaks too hard and dont rev the engine, run the car in high gear.

[haroonmcs26]

Salam my fellow pakwheelers! today i called sarwar automobile Peshawar to ask for a sand beige wagon r vxl. he said that one will arrive tonight and you can take delivery tomorrow. so i went there and made the payment of 1035400 rupees including 1 year extended warranty.
the question is that tommorow im gonna pick up my car INSHALLAH and i wanted to ask what to check at the time of delievery? and how to properly break in my car i.e how much speed to maintain how much weight etc. answer would be highly appreciated as tommo am gonna go for delievery INSHALLAH.

Check any damage to paint or body, jack and rod,spare wheels, wheel caps, two keys one manual and one remote key,two service coupon,vehicle manuale and player manual, if vxl then clarion player remote, check any vibration or wobble at speed of 50 to 60 bcz some general tyres r faulty, no tool kit no cigrate lighter in wagn r. Check all fluid lvls,

Sent from my Z4 using Tapatalk