Power steering problem with honda city

[needou]

Means you are also still wondering in the air.... you did not recognized actual fault yet.... that is the reason what i was saying.. in honda, treatment of fault is not a big issue.. but finding the fault is itself a project...

i also changed complete rack QABLI.... but in vain....

I pray that my opinion would go wrong. best wishes for you..

[ussi]

Yes bhai fault is still unlnown
To be honest i havent spent a bit on the steering but yes i have done a lot of khuwari
But no outcome
Main ne kisi chez ko iss lye zyada nhn chaira kyun masla hua rack khulwane k baad
Iss lye im thinking of rebuilding the rack again with oem parts
I know my rod must have been damaged by now because of the tight rack guide but still i will give it a try
Itna kharcha karun ga bass
Ill service the complete rack
Will remove the motor and sensor too
Will clean if there is gerease in there
Lets hope for the best

[needou]

Wish you good luck. waiting to hear good news.

[askai37]

Needou did ur problem solved

[automakerz]

Honda Required High and Proper maintenance.

I am also a CITY 2006 CNG patient and later sell it in a loss of Lac. Engine Check light always blinks. OOf

Now i am also having a CITY 2007 PETROL - Alhamdulillah Much satisfied and stick to PETROL only.

Good Luck

[affanhussain83]

actually ma bhi is situation se guzra hun ..... and the remedy is simple you just have to replace steering box with kabli one.

[shahab_zia]

I have honda city 2006. my EPS light is ok but steering is very hard. Mechanic repaired the steering assembly and he said after some days your steering will become light, after 3 months steering was same, hard, then i showed this to another mechanic, he asked me to have your steering assembly repaird, i got it repaired and steering was still hard. now its been 3 month again, steering is still hard. Any suggestions?

[askai37]

yahoo my steering comes to what it was . just change tyre size in future back to its original size

[shahab_zia]

How?

[askai37]

using honda HDS for calibration and torque wrench for tightening rack guide
checked all wires and connectors take 1.5 yrs to resolve my problem at last

[shahab_zia]

Ok. I have no idea what you just said

[askai37]

bhai sab wires ko multimeter say check kia steering bush ki tightness check ki aur phir scanner say calibrate kiya

[shahab_zia]

Thanks for explaining. Steering bush ko thoRa loose krny se steering light ho jaye ga, but steering assembly will make noise in potholes.

[ussi]

Did you replace the rack then? How much did it cost?

[ussi]

I have same issue got it done 4 times but it still same hard
Everyone says rack change

[affanhussain83]

Try to get the original steering bush first......instead of change the whole rack....you can brought it from Leppon Autos Plaza or Malik Brothers Plaza

[shahab_zia]

Thanks. I have changed the bust twice, but dont know if it was the original one.

[askai37]

why need new bush just re tight it little bit by using alignment wala duct. no need of taking whole assembly out.

[needou]

Nhi asif bhai,,,
pichlay dinon Torque sensor par grip change karai to moamla theek ho gaya,, but wohi kuch din baad phir light on ho gayi,,,
phir us grip ko manually hath say hilaya to eps ON ho gya,,, laikin phir wohi,,, kaafi din tak yehi check kiya,,, iski grip ko tight karta to light chali jaati,,, ab ab yeh howa k tight karnay say bhi nahi jaa rhi,,,
phir main apnay mechanic k pass gaya or grip new change karai or fault chala gaya after calibration,, but workshop say ghar bhi na ponhcha k light on ho gayi eps off.......
you know i faced chest pain and went for detail check up for cardio pain... multiple doctors checked me 2-3 months and finally its diagnosed that i have not any cardio pain but muscular pain due to hard steering of my car....

nothing to say more.........

[needou]

mubarik ho Asif bhai,,, finally you solved