Suzuki Liana coolant overflow from reservoir

[pwuser160967606736]

Assalam u Alaikum

Sabse pehle bohat maafi chahta hun lambi post k lie.

Maine liana li thee recently or us me thermostat valve nikala hua the (M15 1500cc engine swapped) aap ki advise p maine thermostat valve lagwaya jaisa k tamam seniors ye hi advise dete hain k isko nikalne ka matlab engine life khatam.

Sir maine valve khardia or check b kia temperature pe pani boil kar k phir mechanic se lagwalia.valve lagwane k bad 10 km ka safar kia or gari khari rahi 4 ghante us k bad jab me ghar k lie nikla to maine pani check nai kia kioon k mechanic k pass se full kar k laya tha.

Approx 8 km chalane k bad maine dekha k temperature gauge uth raha he ( main continue check kar raha tha ehtiatan) maine foran gari side p laga k bund kardi or check kia to pani reservoir se nikal kar gir gaya tha phir maine sirf switch on kia k fan check karun to fan kaam karraha the maine bottle me pani bhar k gari le aya gari thandi karne k bad maine radiator dekha to pani 1.5 litre dala .

Kindly advise iski kia waja he or kia hal he maine coolant is lie nai dala k agar koi problem ho to at least nuqsan na ho caltex coolant ki 2 bottles li hain maine or distilled water b par ehtiatan main dekhna chahraha tha k agar do din koi problem na hui to coolant dal dunga.

Liana 2007
Fan b auto karwalia he
Valve lagwa chuka hun
Pani bottle me full ho k bahar gir raha he
Kindly help

Jazakallah
Abdul Ghyyoor from Karachi.

[akramarain16]

Dear, Mechanic didn't install the valve properly, as valve Air breather hole must be in correct direction in the valve body otherwise this problem will remain continue.
I did replace my Liana valve my self and had the same problem, then I open again and installed the valve as per liana service manual.
my problem were solved and car is running perfectly.

[xenerking]

I guess, there was air trapped in the engine and coolant/water wasnt filled up completely, its better to park the car in inclined position with front raised up, press rubber pipes to let any air escape and let engine fan complete 2 3 cycles to make sure coolant in properly filled up, then fill up expansion bottle till half mark.

any air trapped will cause steam in engine and coolant will flow to expansion bottle causing engine heat up etc.