Toyota 2C engine Cold Start Device (CSD)

[alishankhann]

Aoa my 2001 indus corolla with 2C engine has its CSD stuck, i checked it as asked by @Xulfiqar..Now i am having it disassembled from pump to derust it with some cotric acid or vinegar as i read in previous threads of sir @Xulfiqar…but the problem is that if i disassemble CSD from pump in toyota 2C which is front facing the radiator, am i going to see leakage in dieael fuel or not? As its placed on injection pump thats why i am skeptical about this, do i need to follow some precautionary measures before disassembling it from pump or i just do it and wont see any diesel fuel leakage from backside of CSD?

Please enlighten me about this so that i start this process
@Xulfiqar your kind advices are needed once again

[alishankhann]

Picture of my car’s CSD

[Xulfiqar]

The csd wont drain any fuel if you remove just the cylinder.

[alishankhann]

Right, so i will remove just cylinder and i can roam in the car without CSD?
Bcz i will derust it at home…

[Xulfiqar]

if you remove it, your cooling system will be open, how will you drive the car?

[alishankhann]

Oh i see, yes i was also thinkinh bcz there are two pipes of coolant, so you mean i must open it when car is static and derust it and then install it?.

[Xulfiqar]

Make sure it works before installing

[alishankhann]

Yes i will as you taught us in previous threads

[alishankhann]

Aoa sir, today i changed engine oil to my 2C, the filter they gave me was Toyota 90915-30002-8T the bigger one, they said this is of toyota 2c engine, while previously i had 90915-30003-8T the smaller one in it…
He was of the view that both are fine smaller came in previous 2C while in later engine they gave larger filter
Sir is it okay to use this filter? Or shall i change it back
As PSO oil change guy said its fine no problem to have this
Your precious comments on this pls?

[alishankhann]

Plus i put PSO Deo 8000 15w-40 , didnt go for caltex delo gold
Is it ok to use PSO??
Bought from company operated PSO station

[alishankhann]

Sir where is the engine oil pressure sensor located in toyota 2C engine, as somehow my car isn't indicating engine oil pressure sign while turning ignition on..i think its faulty or disconnected

[alishankhann]

I took a picture near oil filter, is it oil pressure sensor?
I dont get any light while turning ignition
What may be the culprit?

[Xulfiqar]

Yes thats it

Make sure the bulb is good.

[alishankhann]

Its not showing that oil sign in speedometer while turninv ignition switch as it shows in every car
So switch may be faulty then?

[Xulfiqar]

Test the circuit by grounding the circuit, if it doesnt show when grounded, your bulb is shot.

[alishankhann]

Will do tomorrow in sha Allah

[pwuser163326471773]

Salam bhai
Mayra 2c T engine ha jb gari thandi hoti ha bohat mazay sa start hoti ha subha saweyray
Laykin jb 30mins, 1hr run karnay k bad off karo gari ko and phir minute 2, minute ma start karo to start nahi hoti

Jb tk 10 sa 12minute na lay lo

Kya wajha ho sakri ha????
My watsapp 03084424969