Vibration after new clutch

[pwuser151932973252]

Yesterday installed
New clutch plate(FCC)
New pressureplate
new clutch cylinder(as previous one got leaked)
new bearing
Now the problem is on releasing clutch on first gear or on reverse car vibrates badly that dashboard and engine vibrate badly but on 2,3,4,5 gear it is perfectly fine.
Mechanic said it can be due to i touched plate with oily hand and if it is not gone will open it again.
What do you guys thinks what happen

[makniazi]

improper facing of flywheel

[aliaamar1101]

This post was flagged by the community and is temporarily hidden.

[mehrozniazi1]

when ever u buy ..... take flywheel along n set pressure...secondly if pressure plate needs balancing do it ...most of the new pressure plates vibrate sometime ..... so do it before using them

[Xulfiqar]

did you burnish the clutch or just went wheelspinning after the job.

[pwuser151932973252]

Burnish ?

[pwuser151932973252]

Hmm may be waiting for one week to see if it gets better.

[pwuser151932973252]

my mechanic said if it does not get better we will change the pressure plate may it is the main fault......

[pwuser151932973252]

moreover he changes all the seal of gear and change oil also and pour about 2.5 bottle of oil still gear is hard to shift

[pwuser151067492819]

Had this issue in alto vxr couple of years back. It kept jerking for weeks and mechanic didn't fix it. Later I found, Pressure plate of khyber was used by mechanic. Next time i used a kabli pressure plate and new clutch plate. Clutch was very smooth immediate after installation.

My advice is to get it opened asap. And get the pressure/clutch plate checked on machine.
Coz mechanic would say "sir ab ye tu use hugai hai" if u do after a week.

[pwuser15183417351]

Your cars Clutch and flywheel need facing. Apka mechanic jhoota hai. He don't know the work and problem, that's why he was saying u that u hold it with oily hands

[pwuser151932973252]

Dubara khola isne or shayad sahi bithaya ha aur ab alhamdulliah sahi hogya

[Xulfiqar]

when you install a new friction disc - you have to burnish it in just like brakes, otherwise it will warp and have hot spots all around which will cause shuddering.

[pwuser152991992157]

copied same problem with me (Honda CF 2005).

A week ago installed
New clutch plate(FCC)
New pressure plate
new clutch cylinder outer(as previous one got leaked)
new bearing
Now the problem is on releasing clutch on first gear or on reverse car vibrates badly that dashboard and engine vibrate badly but on 2,3,4,5 gear it is perfectly fine.
Mechanic says its a gear teeth's issue. can someone please suggest.

[Xulfiqar]

Was the flywheel degalzed?

Did you or the mechanic burnish the clutch after install or you just went “yeet” and “wheel spin” with the new clutch kit?