Vitz 2012 noise inside

[aniazi]

Hello my fellow vitz owners. I recently got fog lights installed in my car. But since the installation there is 'chan' sound whenever the car goes over a bump or a crevice in the road. The noise comes from somewhere near the dashboard and is very annoying for someone who enjoys a noiseless drive. What to do as the person who installed the lights couldn't figure it out.

[ayub.anjum]

Can you please share the pics of fog light in on and off position
And was it installed with dim lights or separate switch
Can you share price for fog lights?

Sent from my iPhone using PW Forums

[aniazi]

Here you go brother.

[aniazi]

Installed with a separate switch

[devilz_apprentice]

KSP-130 comes standard with all the provisions for fitting bumper/fog lights i-e grips and complete wiring harness is already installed from factory. All you have to do is fit the lights in the bumper along and just plug the wiring grips already present.
Since you installed a separate switch, your electrician would have installed complete new wiring and some cutting of the original wires would have been done. This is the reason that your upper right corner of the dashboard is making a noise.
You could have purchased a new light switch from Bilal Gunj which has the extra fog light switch and everything would have been just plug and play.

[aniazi]

The new switch is installed near the gear box where there are pre installed slots for switches so I doubt the cutting of any original wires as it has no connection with the front lights. The point is how to minimise the noise.

[aniazi]

No wiring was cut. The dashboard compartment door was loose and was rectified with extra padding. No more noise now

[ayub.anjum]

Here you go brother.

Bro whats the price for these fog lights?
And did these lights increased the light for night driving
As i m facing too much problem while driving in night
Kindly suggest something for my vitz 2012 import 2015
Kindly tell me some good brand lights

Sent from my iPhone using PW Forums

[ayub.anjum]

KSP-130 comes standard with all the provisions for fitting bumper/fog lights i-e grips and complete wiring harness is already installed from factory. All you have to do is fit the lights in the bumper along and just plug the wiring grips already present.
Since you installed a separate switch, your electrician would have installed complete new wiring and some cutting of the original wires would have been done. This is the reason that your upper right corner of the dashboard is making a noise.
You could have purchased a new light switch from Bilal Gunj which has the extra fog light switch and everything would have been just plug and play.

Brother can you guide me about the wattage of fog lights for KSP130 if i install it with original wiring harness already present in bumper
As i heard that installing high wattage lamp will effect the electrical system of the vehicle????

Sent from my iPhone using PW Forums