Dashboard has been fit in.
Almost all the electrical stuff has been done.
Since there was no alteration/cutting done with the FF wiring harness so it was more of a grip to grip fitting.
However some of the wiring harness in the engine bay were unwrapped due to water and heat.
They were properly and carefully covered with insulation tape.
The car was taken for an inner and outer wash.
Me and a friend first used compressed air to blow away the dust from the wiring harness and then used a damp cloth to wipe them clean.
Any idea that how can I get rid of the water/moisture absorbed by the insulation/underlay at the firewall?
It is still damp and has lots of moisture in it.
This mount got slightly damaged after the crash and had to be changed.
Got it from a G10 in a scrap yard.
Fits perfectly!
Got new antenna and bumper lights.
Got white ones for a change.
Also got orange lenses that if I didnt like them then will change the lenses.
Headlamps attached.
Now fitting bumper.
