SER_GTR's Nissan B13 GA15DS Swap

[SER_GTR]

After My Last Swap In My Sunny........Which Was E15s...........I Finally Endup With GA Series This Time .........Swapped GA15DS ECC..(Electronic Controlled Carb) .....Wired The ECC Myself As Always And Dang

Didn't Have Much Time To Take Lots Of Pics But Here Are Some....

Inspecting Motor Before Swap.....!!!

Preparing For Wiring Work

The Loom Mess.....

Finally Getting Into Shape......!!!

Marking Grips For Ease Of Identifying Pinout

GA Inside.... )

The Interior Mess......!! A/C Work + Cluster Installation

The ECC Box...A One Of Its Kind And Rare Item......

Loom And ECC Box....

The Pin-out Which Helps Me Out....

Installed RPM Type Meter With LED's......!!

Installed This Genuine NISSAN Muffler On 48mm Piping With 12" Resonator..Sounds Quiet Silent And Amazing On Top End....

Engine Starts Right On 1st Crank With ECC MASHALLAH Idling All Well And Revving All Good......!!! Need To Adjust Mixture And Timing........!!!
This Motor Rev's Quiet Freely Even On No Mods......!!!
The Motor I Got Is Almost Like Brand New So Overall A Successful Swap And Happy With Results Takes My Whole Week But Worth It )

[060276]

very nice swap ..more pictures .

[20gze]

Clean engine..clean work..you did a great job again..

[asad1]

nice job

[SER_GTR]

I Am Short On Pics This Time As Busy Almost Working Out On Swap......!!! I Have To Supervise each And every work......And Wiring Was A 70/30 Job....So No Pics....Will Post Pics Of Swapped Motor And Final Looks

[mehrozniazi1]

great....nice work....

[wasay_ahmed]

great as always so did the 3rd swap MashaAllah

[celica]

Nice job farrukh bhai.

[KamranAslam]

Farrukh, no doubt the engine looks, very less used, in 6th pic, off-course the dirt comes with a passage of time.

Did it got mounted on the previous engine supports, or you made some changes to it ??

Share results ASAP.

[SER_GTR]

Engine Is Like Brand New....... Its Quiet Dirty Else The Closer Parts Will Tell You How Much Low Mileage It Is........!!! Even The Engine Oil In It Is New And I Am Running It On Same Engine Oil And Filter
Brackets Remain Same.............Timing Side Mount Need To Be Changed On B13 Rest Gear Side And Back Side Mount Is Bolt-on.....Axles Bolt-On
This Engine Got 4 Mount....The Front One Need To Be Built As Old One Only Have 3 Mounts....!!
Power Steering Lines need To Be Changed Along With Power Steering Fluid Bottle.....!!

Results......So MASHALLAH MASHALLAH......I Am Very Much Satisfied....Today Was 1st Day Of Drive And It Amazes Me....Never Fell Underpowered Even On 48mm Piping.......All The Low End Torque Is There........

I Put Sanden SD-507 Piston Type A/C Compressor On It And It Just Freezes on R134A .........!!!
Worth The Swap.........

[SER_GTR]

Here I Am Uploading Some More Pics To Have An Idea Of How Clean The Motor Is MASHALLAH

Carburetor View....The Shine Of Galvanizing Is There.....

The View Of Water Jackets On Block.....

The Top Of Carburetor View.....

The A/C Compressor Came With It.....Unfortunately It Didn't Work Well...For Some Reason....

The Starter.......Tags Are Intact Everywhere On Every Part....

[saad02]

nyce

[KamranAslam]

the cover of the engine exhausts tell what the engine is. Plus the engine oil thing LUCKY YOU to own it

[hanzala]

great job done!

[waqitariq]

nice swap!

[SER_GTR]

@All Thanks For Appreciations

[Vaqas1]

As Always outstanding work

The motor looks clean and you are very good at wiring.

[DCcoolguy]

great job

[2c]

you are one telanted person

[raja_shahbaz]

awesome man good job done