Tips for Baleno

[mohsinmahar]

Then i already clean it
See my earlier post

[mohsinmahar]

Did anyone know about coil resistance

[mohsinmahar]

And today I clean heater with synthetic vinegar and water

[Horse_rider]

I am new to the forum, have bought Baleno recently.
I have few questions.
1. Please share some addresses and phone numbers of Kabli parts dealers in Rawalpindi
2. I need back spoiler & front chrome grill
3. From where to find dashboard/center console hole covers
4. Which OBD scan tool works with Baleno
5. Want to remove hydraulic steering and install EPS, any suggestions

[Horse_rider]

I have diagnosed my Baleno with the jumper wire method, and got two codes. 32 and 47 one is for MAP sensor while the second one is for CAM sensor. I think cam sensor needs to be replaced while the Map sensor can be cleaned. Am I right?

[safeerabbas]

Though m mot sure about the codes. Cam sensor u can get from waseem autos in rawalpindi @1250 rs. I checked there today. Although i already got the kabli cam sensor @ 1000 rs.

[safeerabbas]

If u r looking for new chrome grill u can get from koh e noor autos in saddar. Price is 2500. Its same design like original.
If u find any other design for grill n back spoiler do post shop details plz as i am also looking for spoiler.

[Horse_rider]

Thanks bro, can you please share name address and locations of some kabli shops

[Horse_rider]

What symptoms were you getting for the CAM sensor. My car is running okay stilo i am getting the codes. A sligh steering vibration during idle

[ch.imran228]

Cam sensor can be cleaned rather it should be cleaned periodically. I did it my self it's easy just lie down under car and you will see it near driver side wheel under engine it will be covered with small rubber boot pull it and loosen one bolt size 10 and sensor is in your hand.
If u find it black just clean it with petrol or any other cleaner u have. It will be golden tip after that.
Just fit it back it is seeled part. Your worries will be gone.

[ch.imran228]

Clean all sensors and there connectors plugs (gutkay), clean all injectors plugs , clean spark plugs them self, clean coils nipples .
Use contact cleaner (non oily) I think u will get results I do this every 3 months by my self. Even I have cleaned injectors also which resulted in smooth Roma.
Reason small dirt particles and carbon accommodate on points and we think sensor is bad.

[Horse_rider]

The sensor you stated is a crank sensor, the CAM sensor is attached to the head, I think its a sealed unit and doesn't require any cleaning. There is a magnet inside which detects the CAM and Crank position when it gets near to the CAM/CRANK, once the magnet gets weak so the signal thats why those sensors need replacement. The MAP sensor requires cleaning though as you mentioned.

[pwuser156129843833]

Aslamoalikum friends.
I have purchased baleno 2005, require supension repaire, where to go in rawalpindi or islamabad, how much will be required for repair

[ch.imran228]

Yes when I removed mine it was having greesy type black material on tip. Which automatically makes magnet strength less.
Material was just like u find under engine black
That's y its tip need cleaning.

[adidas]

Can ayone from Lahore plz let me know how good are the olympia motors in Gulberg as I want to get the headgasket replaced for my baleno. Thanks.

@xenerking

[xenerking]

i personally dont have any experience with olympia motors, however suzuki township has many supervisors who know how to get it done properly.

[adidas]

But suzuki township motors have moved from their previous location I think. Do you know their current lication if you have visited them recently. Plz let me know as I need to get it done tomorrow since car got heated up again and now gaskit has surely been compromised.

[RehanBhatti]

since car got heated up again and now gaskit has surely been compromised.

How you know that it has been compromised? What symptoms you are observing?

[adidas]

Foam inside engine oil cap and water mixing when I check the dip stick and then in this weather radiator is reducing water after every few kms and car heating up even with the direct fan.

[adidas]

@xenerking just one more point should I drive it say for around 20kms considering its reducing water after every 10 to 15 kms. Or should I toe it to the workshop?