Toyota Vitz Engine 1KR-FE Rebuild is better than Half Assembly Swap

[rajaatta]

Yes but the ground realities are different will discuss them too

[dms664]

3.6L with oil filter

Overfilling is overkilling
Nah it's too much just check the owner manual. You will be convinced that it's max 3.1L.
FYI a Corolla 1.3 needs 3.5L.
Corolla 1.5 needs 3.7L.
So how come some stupids keep on pouring 3.6L in a tiny 1.0L engine.
Ap easily 3.0L use kre koi problem nhi hogi.

a Corolla 1.3 with 2nzfe needs 3.7 litres according to manual

[anon36782927]

This post was flagged by the community and is temporarily hidden.

[sharib99]

Sir how was your experience.can u share your contact number

[muddaser_pervaiz]

I do have vitz 2012 japan model, import in 2016. Currently, 74000km done and it need head assembly replacement as it omit bluish/black smoke on hard acceleration. Inspected from various mechanic in lahore. All i want to say that idea of over haul is also in my mind but due to not having a single person opinion i am not able to decide either i will go for used head assembly or over haul. A pak wheel member suggest me to visit Lube Shop locate hardly 5 minutes drive to my place but at that time main person name “Ali” bhai was not there rather another person on his workshop suggest me to go for over haul after having 2 minutes coversation that how much oil car consume presently from ahead i stated that about it will need 200 ml oil to keep oil level full while drive in city rather needed around more then half litre on long route (trip of 700 to 800km).
I find Raja Atta, quiet active and confident about his work but approach matter as i am in lahore so dear can you provide service in lahore, and these days due to Covid 19 reason i find this time can be utilize in a best way to get done work . So member kindly help me as i do want to keep car with me which option shall i consider.

[capsat]

110 Tipu Block Garden Town Lahore is the place dial 0321 4106898 appointment. during lock down realxed hours. for estimate / diagnostics charges apply

[meerzzz]

Please stop advertising for the gentleman as he never has anytime, his schedule is tighter than prime minister of Pakistan , the attitude is pretty bad plus the extra ordinary over charging .... no offence but if you advertise this as a helping hand to fellow PakWheelers ... I politely disagree (I live in Tipu block and have tried reaching out more than 10 times but always the result has been the same)

[muddaser_pervaiz]

Fine. Meanwhile I have little conversation with Raja Atta Khan whom I find quiet knowledgeable regarding over hauling but as matter of approach he do have his setup in Rawalpindi. Seems good to sell car rather taking enough tension.

[rajaatta]

Keep driving it until the situation in pakistan gets normal.
Have extra oil with tou and refill it every after 1500kms thats thumb rule dont add regularlt on daily or weekly basis

[muddaser_pervaiz]

Ok dear I do consider your option.

[zia1288]

I found about the same person from PW and I have had got many works done from him. He tells me when he is free and I visit him in scheduled day / time.

[rajaatta]

Exactly thats the proper procedure.
All busy persons are not available on the go.
You have to take oppintments for their time.

[Xulfiqar]

helping hand to fellow PWers?

[rajaatta]

Welcome sir

[ZUKI.AKBAR]

I have same issue n I solve almost but not fully tank empty kro then hioctain fill karo half day thora zaida phir emty kro phir aisay he karo hi octane say 3rd time hi octane full karo jb half say kam ho tu super dalo or 2 tank super 1tank hi octane no need to mix super n hi octane only hi octane or super my experience bro

[ahmedstudio]

there are no Oxygen Sensor installed on 2013 vitz.

Is there a catalytic converter in 3rd gen Vitz? How is oxygen measurement compensated in absence of O2 sensor?

[rajaatta]

Its AFR (Air fuel ratio) aka Lambda sensor not the conventional oxygen sensor.

[ahmedstudio]

Is it installed at the same location on catalytic converter as the 2nd gen Vitz?

[rajaatta]

Yes same as 2nd gen vitz but have different base part number all old oxygen sensors have part number starting from 89465-xxxxx
And AFR sensors start with
89467-xxxxx

[saadhaq]

I have Platz 2003 with 1 SZ-FE engine. Please guide me if i perform a compression test then what must be the result, need to know the reading for a perfect engine.

Actually the problem is engine is consuming oil on long route specially on high speed like on motorways etc. Initially there was a seal leakage which was done but still now oil is consuming.

1- There is no reduction in engine power, going smooth and fine.
2- No reduction in petrol consumption, fine and good.
3- Black smoke, if pedal is pushed extra hard while in stationary position.

Please guide.